Stellwagen A, Stellwagen N C
Department of Biochemistry, University of Iowa, Iowa City 52242.
Biopolymers. 1990;30(3-4):309-24. doi: 10.1002/bip.360300309.
The effect of gel pore size on the anomalous mobility of certain curved DNA restriction fragments in polyacrylamide gels was studied by comparing the electrophoretic mobilities of normal and anomalous fragments in gels of varying composition but constant acrylamide concentration. Molecular weight ladders were prepared from two 147 base pair G-C rich restriction fragments, called 12A (anomalous) and 12B (normal), obtained from the MspI digestion of plasmid pBR322. The electrophoretic mobilities of multimers of the two fragments increasingly diverged with increasing molecular weight. The anomalous mobility of fragment 12A was essentially independent of gel pore size, regardless of whether the pore size was varied by increasing the acrylamide concentration at constant cross-linker concentration or by increasing the cross-linker concentration at constant acrylamide concentration. The anomalous mobility of higher multimers of fragment 12A decreased with increasing gel pore size when the pore size was varied by changing the gel concentration. However, when the gel pore size was changed by varying the cross-linker concentration at constant acrylamide concentration, the anomalous mobility of higher multimers of fragment 12A went through a maximum and then decreased as the pore size was increased. Copolymerizing acrylamide with high molecular weight linear polyacrylamides had no effect on the anomalous mobility of the 12A multimer ladder, even though the apparent absolute mobilities of all fragments increased markedly. Only by incorporating charged residues into the gel matrix or by copolymerizing acrylamide with the intercalator ethidium bromide could the difference in mobility between the 12A and 12B multimer ladders be substantially reduced or eliminated. Similar results were observed with a molecular weight ladder containing 78 base pair repeats of the bending locus of kinetoplast DNA. These results suggest that pore size alone is not responsible for the anomalously slow migration of curved DNA molecules in polyacrylamide gels.
通过比较不同组成但丙烯酰胺浓度恒定的凝胶中正常片段和异常片段的电泳迁移率,研究了凝胶孔径对聚丙烯酰胺凝胶中某些弯曲DNA限制片段异常迁移的影响。分子量标准由两个富含G-C的147碱基对限制片段制备而成,分别称为12A(异常)和12B(正常),它们是从质粒pBR322的MspI消化产物中获得的。随着分子量增加,这两个片段的多聚体的电泳迁移率差异越来越大。片段12A的异常迁移基本上与凝胶孔径无关,无论孔径是通过在交联剂浓度恒定的情况下增加丙烯酰胺浓度来改变,还是通过在丙烯酰胺浓度恒定的情况下增加交联剂浓度来改变。当通过改变凝胶浓度来改变孔径时,片段12A较高多聚体的异常迁移率随凝胶孔径增大而降低。然而,当在丙烯酰胺浓度恒定的情况下通过改变交联剂浓度来改变凝胶孔径时,片段12A较高多聚体的异常迁移率先达到最大值,然后随着孔径增大而降低。将丙烯酰胺与高分子量线性聚丙烯酰胺共聚对12A多聚体分子量标准的异常迁移没有影响,尽管所有片段的表观绝对迁移率都显著增加。只有通过将带电残基引入凝胶基质或使丙烯酰胺与嵌入剂溴化乙锭共聚,才能大幅降低或消除12A和12B多聚体分子量标准之间的迁移率差异。用含有动质体DNA弯曲位点78碱基对重复序列的分子量标准也观察到了类似结果。这些结果表明,仅孔径大小并不能解释弯曲DNA分子在聚丙烯酰胺凝胶中异常缓慢迁移的现象。