Department of Orthopaedic Surgery, University of Arizona, Tucson, 85724, USA.
Am J Sports Med. 2011 Dec;39(12):2662-9. doi: 10.1177/0363546511422987. Epub 2011 Sep 21.
Osteochondral allograft transplantation is technically demanding. It is not always possible to place the surface of the graft perfectly flush with the surrounding cartilage. One must often choose between placing at least some portion of the surface of the graft slightly elevated or recessed. The effect of this choice on joint contact pressure is unknown.
This study was undertaken to determine the effect of graft height mismatch on joint contact pressure in the ankle.
Controlled laboratory study.
Ten human cadaveric ankles underwent osteochondral grafting by removal then replacement of an osteochondral plug. Six conditions were tested: intact, graft flush, graft elevated 1.0 mm, graft elevated 0.5 mm, graft recessed 0.5 mm, and graft recessed 1.0 mm. Joint contact pressures were measured with a Tekscan sensor while loads of 200 N, 400 N, 600 N, and 800 N were sequentially applied.
The peak contact pressure at the graft site for the flush condition was not significantly different from the intact condition for either medial or lateral lesions. In contrast, peak pressure on the opposite facet of the talar dome was significantly increased during the flush condition for the medial but not the lateral grafts. Elevated grafts experienced significantly increased contact pressures, whereas recessed grafts experienced significantly decreased pressures. These changes were greater for lateral than for medial lesions. Reciprocal changes in joint contact pressures were found on the opposite facet of the talus with elevated grafts on the lateral side and recessed grafts on the medial side.
Flush graft placement can restore near-normal joint contact pressure. Elevated graft placement leads to significant increases in joint contact pressure at the graft site. Recessed graft placement leads to a transfer of pressure from the graft site to the opposite facet of the talus.
Osteochondral grafts in the talus should be placed flush if possible or else slightly recessed.
骨软骨同种异体移植技术要求高。要使移植物的表面与周围软骨完全吻合并非总是可行的。人们经常需要在将移植物的表面至少部分略微抬高或凹陷之间做出选择。这种选择对关节接触压力的影响尚不清楚。
本研究旨在确定距骨骨软骨移植中移植物高度不匹配对关节接触压力的影响。
对照实验室研究。
10 个人体尸体踝关节通过切除然后替换骨软骨栓进行骨软骨移植。共测试了 6 种情况:完整、移植平齐、移植抬高 1.0mm、移植抬高 0.5mm、移植凹陷 0.5mm 和移植凹陷 1.0mm。在施加 200N、400N、600N 和 800N 顺序载荷时,使用 Tekscan 传感器测量关节接触压力。
平齐条件下,内侧或外侧病变的移植物部位的峰值接触压力与完整条件相比无显著差异。相比之下,平齐条件下距骨顶部对侧关节面的峰值压力在内侧移植物中显著增加,但在外侧移植物中没有增加。抬高的移植物的接触压力显著增加,而凹陷的移植物的接触压力显著降低。这些变化在外侧病变中比在内侧病变中更为明显。在外侧移植物抬高和内侧移植物凹陷的情况下,距骨对侧关节面的关节接触压力会发生相反的变化。
平齐放置移植物可恢复接近正常的关节接触压力。抬高的移植物放置会导致移植物部位的关节接触压力显著增加。凹陷的移植物放置会导致压力从移植物部位转移到距骨对侧关节面。
如果可能的话,距骨的骨软骨移植物应平齐放置,否则应稍微凹陷。