Department of Chemistry and Biochemistry, Brigham Young University, Provo, UT 84602, USA.
J Chromatogr A. 2011 Nov 18;1218(46):8362-9. doi: 10.1016/j.chroma.2011.09.041. Epub 2011 Sep 21.
Porous graphitic carbon (PGC) particles were functionalized/passivated in situ in packed beds at elevated temperature with neat di-tert-amylperoxide (DTAP) in a column oven. The performance of these particles for high performance liquid chromatography (HPLC) was assayed before and after this chemistry with the following analytes: benzene, toluene, ethyl benzene, n-propyl benzene, n-butyl benzene, p-xylene, phenol, 4-methylphenol, phenetole, 3,5-xylenol, and anisole. After the first functionalization/passivation, the retention factors, k, of these compounds decreased by about 5% and the number of theoretical plates (N) increased by ca. 15%. These values of k then remained roughly constant after a second functionalization/passivation but a further increase in N was noticed. In addition, after each of the reactions, the peak asymmetries decreased by ca. 15%, for a total of ca. 30%. The columns were then subjected twice to methanol at 100°C for 5h at 1 mL/min. After these stability tests, the values of k remained roughly constant, the number of plates increased, which is favorable, and the asymmetries rose and then declined, where they remained below the initial values for the unfunctionalized columns. Functionalized and unfunctionalized particles were characterized by scanning electron microscopy and BET measurements, which showed no difference between the functionalized and unfunctionalized materials, and X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectrometry (ToF-SIMS), where ToF-SIMS suggested some chemical differences between the functionalized and unfunctionalized materials. In particular ToF-SIMS suggested that the expected five-carbon fragments from DTAP exist at higher concentrations on DTAP-functionalized PGC. First principle calculations on model graphitic surfaces suggest that the first addition of a DTAP radical to the surface proceeds in an approximately isothermal or slightly favorable fashion, but that subsequent DTAP additions are then increasingly thermodynamically favorable. Thus, this analysis suggests that the direct functionalization/passivation of PGC with DTAP is plausible. Chemometric analyses of the chromatographic and ToF-SIMS data are also presented.
多孔石墨碳(PGC)颗粒在柱烘箱中于高温下用纯二叔丁基过氧化物(DTAP)原位功能化/钝化在填充床中。在用以下分析物对这些颗粒进行高效液相色谱(HPLC)性能测试之前和之后,对其进行了评估:苯、甲苯、乙苯、正丙苯、正丁苯、对二甲苯、苯酚、4-甲基苯酚、苯乙醚、3,5-二甲酚和苯甲醚。在第一次功能化/钝化之后,这些化合物的保留因子 k 降低了约 5%,理论板数(N)增加了约 15%。在第二次功能化/钝化之后,k 的这些值大致保持不变,但注意到 N 进一步增加。此外,在每次反应之后,峰形不对称性降低了约 15%,总共约为 30%。然后,将这些柱子在 100°C 下以 1 mL/min 的流速用甲醇处理两次,每次 5 小时。在这些稳定性测试之后,k 的值大致保持不变,板数增加,这是有利的,不对称性上升然后下降,它们保持在未功能化柱子的初始值以下。通过扫描电子显微镜和 BET 测量对功能化和未功能化的颗粒进行了表征,结果表明功能化和未功能化材料之间没有区别,X 射线光电子能谱和飞行时间二次离子质谱(ToF-SIMS),其中 ToF-SIMS 表明功能化和未功能化材料之间存在一些化学差异。特别是,ToF-SIMS 表明,在 DTAP 功能化的 PGC 上,DTAP 的预期五碳片段以更高的浓度存在。对模型石墨表面的第一性原理计算表明,DTAP 自由基首次添加到表面的过程以近似等温和稍微有利的方式进行,但随后的 DTAP 添加则越来越热力学有利。因此,这种分析表明,PGC 与 DTAP 的直接功能化/钝化是合理的。还呈现了色谱和 ToF-SIMS 数据的化学计量学分析。