Department of Otolaryngology, SUNY Upstate Medical University, Syracuse, New York 13210, USA.
Laryngoscope. 2011 Nov;121(11):2299-304. doi: 10.1002/lary.22170.
Compare circular defect with dog-ear deformities excision (CDDE) technique to 3:1 fusiform excision technique when removing facial lesions to analyze which technique provides superior wound closure.
Identical 1-cm circular skin defects were created on bilateral cheek, forehead, and parietal scalp on three fresh cadavers. Similarly, using four fresh cadavers, identical 2-cm circular skin defects were created on bilateral cheek, forehead, and scalp. In both the 1-cm and 2-cm circular defects (n = 19), a 3:1 fusiform excision and closure was performed on one side of the cadaver head for control. On the opposite side, CDDE excision technique was performed. The following measurements were recorded: circumferential incision length after tissue excision, average of wound widening widths after an approximation suture was placed at the halfway point, and the final incision length after primary closure. Final incision length upon closure was divided by the original defect size to obtain a final incision length to defect ratio. A paired t-test was performed on all variables for analysis.
When using the CDDE excision technique, there were statistically significant decreases in circumference, average wound widening, final incision length in both 1-cm and 2-cm circular defects (P < .01). The final incision length upon closure to defect ratio in CDDE excision was approximately 2.5:1, whereas 3:1 fusiform excision resulted in the final incision length to defect ratio of approximately 3.5:1.
When compared to fusiform excision technique, CDDE excision technique appears to minimize tissue excision, decrease wound widening and the final incision length.
比较环形缺损与狗耳畸形切除(CDDE)技术与 3:1 梭形切除技术在去除面部病变时的伤口闭合效果,以分析哪种技术提供更好的伤口闭合效果。
在三个新鲜尸体的双侧脸颊、额头和顶骨头皮上创建相同的 1cm 圆形皮肤缺损。同样,使用四个新鲜尸体,在双侧脸颊、额头和头皮上创建相同的 2cm 圆形皮肤缺损。在 1cm 和 2cm 圆形缺损(n=19)中,在尸体头部一侧进行 3:1 梭形切除和闭合作为对照。在对侧,进行 CDDE 切除技术。记录以下测量值:组织切除后的周向切口长度、放置在中点处的近似缝线后的平均伤口增宽宽度以及初次闭合后的最终切口长度。初次闭合后的最终切口长度除以原始缺损大小,得到最终切口长度与缺损的比值。对所有变量进行配对 t 检验分析。
使用 CDDE 切除技术时,1cm 和 2cm 圆形缺损的周长、平均伤口增宽和最终切口长度均有统计学显著减少(P<.01)。CDDE 切除的最终切口长度与缺损的比值约为 2.5:1,而 3:1 梭形切除的最终切口长度与缺损的比值约为 3.5:1。
与梭形切除技术相比,CDDE 切除技术似乎可以减少组织切除量,减少伤口增宽和最终切口长度。