ISIS Facility, STFC Rutherford Appleton Laboratory, Harwell Science and Innovation Campus, Didcot, Oxon, OX11 0QX, UK.
J Phys Condens Matter. 2012 Feb 15;24(6):064107. doi: 10.1088/0953-8984/24/6/064107. Epub 2012 Jan 25.
Recently, water absorbed in the porous silica material MCM-41-S15 has been used to demonstrate an apparent fragile to strong dynamical crossover on cooling below ∼220 K, and also to claim that the density of confined water reaches a minimum at a temperature around 200 K. Both of these behaviours are purported to arise from the crossing of a Widom line above a conjectured liquid-liquid critical point in bulk water. Here it is shown that traditional estimates of the pore diameter in this porous silica material (of order 15 Å) are too small to allow the amount of water that is observed to be absorbed by these materials (around 0.5 g H(2)O/g substrate) to be absorbed only inside the pore. Either the additional water is absorbed on the surface of the silica particles and outside the pores, or else the pores are larger than the traditional estimates. In addition the low Q Bragg intensities from a sample of MCM-41-S15 porous silica under different dry and wet conditions and with different hydrogen isotopes are simulated using a simple model of the water and silica density profile across the pore. It is found the best agreement of these intensities with experimental data is shown by assuming the much larger pore diameter of 25 Å (radius 12.5 Å). Qualitative agreement is found between these simulated density profiles and those found in recent empirical potential structure refinement simulations of the same data, even though the latter data did not specifically include the Bragg peaks in the structure refinement. It is shown that the change in the (100) peak intensity on cooling from 300 to 210 K, which previously has been ascribed to a change in density of the confined water on cooling, can equally be ascribed to a change in density profile at constant average density. It is further pointed out that, independent of whether the pore diameter really is as large as 25 Å or whether a significant amount of water is absorbed outside the pore, the earlier reports of a dynamic crossover in supercooled confined water could in fact be a crystallization transition in the larger pore or surface water.
最近,在多孔二氧化硅材料 MCM-41-S15 中吸收的水已被用于证明在冷却至约 220 K 以下时,动态行为从明显的脆弱向强转变,并且还声称被限制水的密度在温度约为 200 K 时达到最小值。这两种行为都被认为是在体相水中的 Widom 线交叉之上产生的,而 Widom 线交叉被认为是在体相水中的液-液相变临界点之上产生的。这里表明,对这种多孔二氧化硅材料(约 15 Å)的孔径的传统估计太小,以至于无法仅在孔内吸收观察到的被这些材料吸收的水量(约 0.5 g H(2)O/g 基质)。要么是更多的水被吸收在二氧化硅颗粒的表面和孔外,要么是孔比传统估计的要大。此外,在不同的干燥和湿润条件下以及具有不同氢同位素的 MCM-41-S15 多孔二氧化硅样品的低 Q Bragg 强度使用穿过孔的水和二氧化硅密度分布的简单模型进行了模拟。发现通过假设更大的孔直径为 25 Å(半径为 12.5 Å),可以最好地使这些强度与实验数据一致。即使后者的数据并未专门包括结构精修中的 Bragg 峰,也发现这些模拟密度分布与最近对相同数据的经验势结构精修模拟中的那些分布具有定性一致性。结果表明,在从 300 K 冷却到 210 K 时,(100)峰强度的变化,以前归因于冷却时受限水密度的变化,同样可以归因于平均密度不变时密度分布的变化。进一步指出,无论孔径是否真的像 25 Å 那样大,或者是否有大量的水被吸收在孔外,关于过冷受限水中的动力学交叉的早期报道实际上可能是更大孔或表面水中的结晶转变。