School of Marine and Atmospheric Science, Stony Brook University, Stony Brook, NY 11794-5000, USA.
Geochem Trans. 2012 Feb 7;13:3. doi: 10.1186/1467-4866-13-3.
The abundant iron sulfide mineral pyrite has been shown to catalytically produce hydrogen peroxide (H2O2) and hydroxyl radical (.OH) in slurries of oxygenated water. Understanding the formation and fate of these reactive oxygen species is important to biological and ecological systems as exposure can lead to deleterious health effects, but also environmental engineering during the optimization of remediation approaches for possible treatment of contaminated waste streams. This study presents the use of the amino acid phenylalanine (Phe) to monitor the kinetics of pyrite-induced .OH formation through rates of hydroxylation forming three isomers of tyrosine (Tyr) - ortho-, meta-, and para-Tyr. Results indicate that about 50% of the Phe loss results in Tyr formation, and that these products further react with .OH at rates comparable to Phe. The overall loss of Phe appeared to be pseudo first-order in [Phe] as a function of time, but for the first time it is shown that initial rates were much less than first-order as a function of initial substrate concentration, [Phe]o. These results can be rationalized by considering that the effective concentration of .OH in solution is lower at a higher level of reactant and that an increasing fraction of .OH is consumed by Phe-degradation products as a function of time. A simplified first-order model was created to describe Phe loss in pyrite slurries which incorporates the [Phe]o, a first-order dependence on pyrite surface area, the assumption that all Phe degradation products compete equally for the limited supply of highly reactive .OH, and a flux that is related to the release of H2O2 from the pyrite surface (a result of the incomplete reduction of oxygen at the pyrite surface). An empirically derived rate constant, Kpyr, was introduced to describe a variable .OH-reactivity for different batches of pyrite. Both the simplified first-order kinetic model, and a more detailed numerical simulation, yielded results that compare well to the observed kinetic data describing the effects of variations in concentrations of both initial Phe and pyrite. This work supports the use of Phe as a useful probe to assess the formation of .OH in the presence of pyrite, and its possible utility for similar applications with other minerals.
富含硫化亚铁的黄铁矿在含氧水中的悬浮液中已被证明能催化产生过氧化氢(H2O2)和羟基自由基(.OH)。了解这些活性氧物质的形成和命运对于生物和生态系统很重要,因为暴露可能导致有害的健康影响,但在优化修复方法以可能处理受污染的废水流时,这对于环境工程也很重要。本研究通过形成三种酪氨酸(Tyr)异构体(邻位、间位和对位 Tyr)的羟化速率,利用氨基酸苯丙氨酸(Phe)来监测黄铁矿诱导的.OH 形成动力学。结果表明,大约 50%的 Phe 损失导致 Tyr 形成,并且这些产物进一步与.OH 以与 Phe 相当的速率反应。Phe 的总体损失似乎在时间上呈伪一级函数,[Phe],但首次表明初始速率在初始底物浓度[Phe]o的函数上远低于一级。这些结果可以通过考虑溶液中.OH 的有效浓度在更高水平的反应物中较低,并且随着时间的推移,.OH 越来越多地被 Phe 降解产物消耗来合理化。创建了一个简化的一级模型来描述黄铁矿悬浮液中的 Phe 损失,该模型包含[Phe]o,与黄铁矿表面积的一级依赖关系,假设所有 Phe 降解产物平等竞争有限的高反应性.OH 供应,以及与黄铁矿表面释放 H2O2(黄铁矿表面氧气不完全还原的结果)相关的通量。引入经验衍生的速率常数 Kpyr 来描述不同批次黄铁矿的可变.OH 反应性。简化的一级动力学模型和更详细的数值模拟都产生了与描述初始 Phe 和黄铁矿浓度变化对观察到的动力学数据的影响的结果相吻合。这项工作支持将 Phe 用作评估黄铁矿存在时形成.OH 的有用探针的用途,并且它可能对其他矿物的类似应用有用。