Department of Medical Physics, British Columbia Cancer Agency, Vancouver, British Columbia, Canada.
Med Phys. 2012 Feb;39(2):721-31. doi: 10.1118/1.3671921.
In postimplant dosimetry for prostate brachytherapy, dose is commonly calculated using the TG-43 1D formalism, because seed orientations are difficult to determine from CT images, the current standard for the procedure. However, the orientation of stranded seeds soon after implantation is predictable, as these seeds tend to maintain their relative spacing, and orient themselves along the implant trajectory. The aim of this study was to develop a method for determining seed orientations from reconstructed strand trajectories, and to use this information to investigate the dosimetric impact of applying the TG-43 2D formalism to clinical postimplant analysis.
Using in-house software, the preplan to postimplant seed correspondence was determined for a cohort of 30 patients during routine day-0 CT-based postimplant dosimetry. All patients were implanted with stranded-seed trains. Spline curves were fit to each set of seeds composing a strand, with the requirement that the distance along the spline between seeds be equal to the seed spacing within the strand. The orientations of the seeds were estimated by the tangents to the spline at each seed centroid. Dose distributions were then determined using the 1D and 2D TG-43 formalisms. These were compared using the TG-137 recommended dose metrics for the prostate, prostatic urethra, and rectum.
Seven hundred and sixty one strands were analyzed in total. Defining the z-axis to be cranial-positive and the x-axis to be left-lateral positive in the CT coordinate system, the average seed had an inclination of 21° ± 10° and an azimuth of -81° ± 57°. These values correspond to the average strand rising anteriorly from apex to base, approximately parallel to the midsagittal plane. Clinically minor but statistically significant differences in dose metrics were noted. Compared to the 2D calculation, the 1D calculation underestimated prostate V100 by 1.1% and D90 by 2.3 Gy, while overestimating V150 and V200 by 1.6% and 1.3%, respectively. Urethral and rectal dose quantifiers tended to be underestimated by the 1D calculation. The most pronounced differences were in the urethral D30 and rectal D2cc, which rose by 3.8 and 1.9 Gy, respectively, using the 2D calculation. The total volume of the 100% isodose region as a percentage of the prostate volume was found to increase by 0.4%.
Stranded seeds in the supine patient are not oriented in a uniformly random manner, nor are they aligned along the axis of the CT scanner. Instead, this study identified a consistent anterior pitch that is likely attributable to differences in patient pose between implant and CT imaging. The angle of the ultrasound probe with respect to the patient during implant may have also been a contributing factor. The dose metrics derived using the 1D formalism were found to be within 2%, on average, of those derived using the 2D formalism. For greater accuracy, 2D dosimetry can be pursued using the strand-fitting method described in this work. If a 1D representation is used, integrating over the empirically determined seed orientation density reported here may be more appropriate than assuming that seed inclinations are distributed uniformly.
在前列腺近距离放射治疗后装治疗的剂量计算中,由于种子的方向难以从 CT 图像确定,因此通常使用 TG-43 1D 公式进行计算,这是目前该程序的标准。然而,植入后不久,绞合种子的方向是可以预测的,因为这些种子往往保持相对间距,并沿着植入轨迹排列。本研究的目的是开发一种从重建的绞合轨迹确定种子方向的方法,并利用该信息研究应用 TG-43 2D 公式对临床后装分析的剂量学影响。
使用内部软件,在常规基于 CT 的植入后第 0 天剂量计算中,确定了 30 例患者的计划到植入后种子对应关系。所有患者均植入绞合种子列车。对每一组构成绞合的种子进行样条曲线拟合,要求样条曲线上种子之间的距离等于绞合内种子的间距。种子的方向通过每个种子质心处的样条切线来估计。然后使用 1D 和 2D TG-43 公式确定剂量分布。使用 TG-137 推荐的前列腺、前列腺尿道和直肠剂量指标对其进行比较。
总共分析了 761 个绞合。在 CT 坐标系中,将 z 轴定义为颅侧为正,x 轴定义为左侧为正,平均种子的倾斜角为 21°±10°,方位角为-81°±57°。这些值对应于绞合从尖端到基底大致从前到后的平均上升,与正中矢状面平行。注意到剂量学指标有临床意义较小但统计学上显著的差异。与 2D 计算相比,1D 计算低估了前列腺 V100 1.1%,D90 2.3Gy,而高估了 V150 和 V200 分别为 1.6%和 1.3%。1D 计算倾向于低估尿道和直肠剂量量化指标。最明显的差异是尿道 D30 和直肠 D2cc,使用 2D 计算分别升高了 3.8 和 1.9Gy。100%等剂量区的总体积占前列腺体积的百分比增加了 0.4%。
仰卧位患者的绞合种子的方向不是均匀随机的,也不是沿着 CT 扫描仪的轴排列的。相反,本研究确定了一种一致的前倾角,这可能归因于植入和 CT 成像之间患者姿势的差异。植入过程中超声探头相对于患者的角度也可能是一个促成因素。使用 1D 公式得出的剂量学指标平均在 2%以内,使用 2D 公式得出的剂量学指标。为了获得更高的准确性,可以使用本文描述的绞合拟合方法进行 2D 剂量计算。如果使用 1D 表示,则可能更适合根据经验确定的种子取向密度来集成,而不是假设种子倾斜度均匀分布。