Department of Chemical Engineering, Istanbul Technical University, Istanbul, Turkey.
Ultrason Sonochem. 2012 Sep;19(5):1108-13. doi: 10.1016/j.ultsonch.2012.01.008. Epub 2012 Feb 9.
Application of power ultrasound, offers potential in the degree of control over the preparation and properties of nanocrystalline zeolites, which have become increasingly important due to their diverse emerging applications. Synthesis of silicalite-1 nanocrystals from a clear solution was carried out at 348 K in the absence and presence of ultrasound of 300 and 600 W, in an attempt to investigate the effects of sonication, in this respect. Variation of the particle size and particle size distribution was followed with respect to time using a laser light scattering device with a detector set to collect back-scattered light at an angle of 173°. Product yield was determined and the crystallinity was analyzed by X-ray diffraction for selected samples collected during the syntheses. Nucleation, particle growth and crystallization rates all increased as a result of the application of ultrasound and highly crystalline silicalite-1 of smaller average particle diameter could be obtained at shorter synthesis times. The particle size distributions of the product populations, however, remained similar for similar average particle sizes. The rate of increase in yield was also speeded up in the presence of ultrasound, while the final product yield was not affected. Increasing the power of ultrasound, from 300 to 600 W, increased the particle growth rate and the crystalline domain size, and decreased both the final particle diameter and the time required for the particle growth to reach completion, while its effect on nucleation was unclear.
超声应用为控制纳米沸石的制备和性质提供了可能,由于其多样化的新兴应用,纳米沸石变得越来越重要。在 348K 下,从澄清溶液中合成 silicalite-1 纳米晶体,在没有和存在 300 和 600W 超声的情况下进行,试图研究超声在这方面的影响。使用激光散射装置,通过收集背散射光的角度为 173°,随着时间的推移,对粒径和粒径分布的变化进行了跟踪。确定了产物收率,并通过 X 射线衍射对所选样品进行了结晶度分析。由于超声的应用,成核、颗粒生长和结晶速率都增加了,并且可以在更短的合成时间内获得结晶度更高、平均粒径更小的 silicalite-1。然而,对于相似的平均粒径,产物群体的粒径分布仍然相似。在超声存在的情况下,产率的增加速度也加快了,而最终产物的产率没有受到影响。从 300W 增加到 600W 超声功率增加了颗粒生长速率和结晶域尺寸,降低了最终粒径和颗粒生长完成所需的时间,而其对成核的影响尚不清楚。