Materials and Energy Research Center, Tehran, Iran.
J Mater Sci Mater Med. 2012 Jul;23(7):1569-81. doi: 10.1007/s10856-012-4637-z. Epub 2012 Apr 13.
In this research, light cured calcium phosphate cements (LCCPCs) were developed by mixing a powder phase (P) consisting of tetracalcium phosphate and dicalcium phosphate and a photo-curable resin phase (L), mixture of hydroxyethylmethacrylate (HEMA)/poly acrylic-maleic acid at various P/L ratios of 2.0, 2.4 and 2.8 g/mL. Mechanical strength, phase composition, chemical groups and microstructure of the cured cements were evaluated at pre-set times, i.e. before and after soaking in simulated body fluid (SBF). The proliferation of Rat-derived osteoblastic cells onto the LCCPCs as well as cytotoxicity of cement extracts were determined by cell counting and 3-{4,5-dimethylthiazol-2yl}-2,5-diphenyl-2H-tetrazolium bromide assay after different culture times. It was estimated from Fourier transforming infrared spectra of cured cements that the setting process is ruled by polymerization of HEMA monomers as well as formation of calcium poly-carboxylate salts. Microstructure of the cured cements consisted of calcium phosphate particles surrounded by polymerized resin phase. Formation of nano-sized needlelike calcium phosphate phase on surfaces of cements with P/L ratios of 2.4 and 2.8 g/mL was confirmed by scanning electron microscope images and X-ray diffractometry (XRD) of the cured specimen soaked in SBF for 21 days. Also, XRD patterns revealed that the formed calcium phosphate layer was apatite phase in a poor crystalline form. Biodegradation of the cements was confirmed by weight loss, change in molecular weight of polymer and morphology of the samples after different soaking periods. The maximum compressive strength of LCCPCs governed by resin polymerization and calcium polycarboxylate salts formation was about 80 MPa for cement with P/L ratio of 2.8 g/mL, after incubation for 24 h. The strength of all cements decreased by decreasing P/L ratio as well as increasing soaking time. The preliminary cell studies revealed that LCCPCs could support proliferation of osteoblasts cultured on their surfaces and no cytotoxic effect was observed for the extracts of them.
在这项研究中,通过混合粉末相(P)和光固化树脂相(L)来制备光固化磷酸钙水泥(LCCPC)。粉末相(P)由磷酸四钙和磷酸二钙组成,而光固化树脂相(L)是由羟乙基甲基丙烯酸酯(HEMA)/聚甲基丙烯酸马来酸组成。以 2.0、2.4 和 2.8 g/mL 的不同 P/L 比混合 P 和 L。在预定时间(即在浸泡在模拟体液(SBF)之前和之后)评估固化水泥的机械强度、相组成、化学基团和微观结构。通过细胞计数和 3-{4,5-二甲基噻唑-2基}-2,5-二苯基-2H-四唑溴盐测定法测定在不同培养时间后 Rat 衍生成骨细胞在 LCCPC 上的增殖和水泥浸提液的细胞毒性。从固化水泥的傅里叶变换红外光谱估计,凝固过程受 HEMA 单体聚合以及钙多羧酸盐形成的控制。固化水泥的微观结构由被聚合树脂相包围的磷酸钙颗粒组成。通过扫描电子显微镜图像和浸泡在 SBF 21 天的固化试样的 X 射线衍射(XRD)证实,在 P/L 比为 2.4 和 2.8 g/mL 的水泥表面形成纳米级针状磷酸钙相。此外,XRD 图谱表明形成的磷酸钙层是无定形形式的磷灰石相。通过不同浸泡期后的重量损失、聚合物分子量变化和样品形貌证实了水泥的生物降解。由树脂聚合和钙多羧酸盐形成控制的 LCCPC 的最大抗压强度约为 80 MPa,用于 P/L 比为 2.8 g/mL 的水泥,孵育 24 小时后。随着 P/L 比的降低和浸泡时间的增加,所有水泥的强度都降低了。初步的细胞研究表明,LCCPC 可以支持在其表面培养的成骨细胞的增殖,并且它们的提取物没有细胞毒性作用。