Key Laboratory of Colloid and Interface Chemistry, Shandong University, Ministry of Education, Jinan 250100, China.
J Phys Chem B. 2012 Jul 5;116(26):7669-75. doi: 10.1021/jp300733x. Epub 2012 Jun 25.
The influence of counterions on micellization of perfluorononanoic carboxylate ammonium salts in water and 1-butyl-3-methylimidazolium tetrafluoroborate ([bmim]BF(4)) solutions was investigated by surface tension and (19)F NMR measurements and freeze-fracture transmission electron microscopy (FF-TEM) observations. Changes in the counterions of the fluorocarbon surfactants have different effects on the two solvents. With the increase of counterion volume, the critical micelle concentration (cmc) value of relevant fluorinated surfactant decreases in aqueous solutions. This is because the counterions with larger size, such as (+)N(CH(3))(4), can be little hydrated, which can screen the electrostatic repulsion of the headgroups of the fluorocarbon surfactant and thus facilitate micelle formation. However, the fluorocarbon surfactants can dissolve and form micelles in [bmim]BF(4) only when they provide with largest counterion such as (+)N(CH(3))(4). This is because the counterion, (+)N(CH(3))(4), disperses the charge of the cations, which could weaken the electrostatic interaction between the ion pair of the surfactant, leading to a higher degree of counterion binding. The thermodynamic parameters estimated from the temperature dependence of the cmc values tell us that the micelle formation for tetramethylammonium perfluorononanoic carboxylate (C(8)F(17)COON(CH(3))(4), PFNT) in ionic liquids (ILs) is an entropy-driven process at low temperature but an enthalpy-driven process at high temperature. The driving force of the micellization for fluorocarbon surfactants in [bmim]BF(4) is the solvophobic effect, due to the hydrophobic and oleophobic properties of fluorocarbon chains.
通过表面张力和(19)F NMR 测量以及冷冻断裂透射电子显微镜(FF-TEM)观察研究了反离子对全氟壬酸铵盐在水中和 1-丁基-3-甲基咪唑四氟硼酸盐([bmim]BF(4))溶液中胶束化的影响。氟碳表面活性剂反离子的变化对两种溶剂有不同的影响。随着反离子体积的增加,相关氟表面活性剂的临界胶束浓度(cmc)值在水溶液中降低。这是因为尺寸较大的反离子,如(+)N(CH(3))(4),几乎不水化,可以屏蔽氟碳表面活性剂的头基的静电排斥,从而有利于胶束形成。然而,只有当氟碳表面活性剂提供最大的反离子,如(+)N(CH(3))(4)时,才能溶解在[bmim]BF(4)中形成胶束。这是因为反离子(+)N(CH(3))(4)分散了阳离子的电荷,从而削弱了表面活性剂离子对之间的静电相互作用,导致更高程度的反离子结合。从 cmc 值随温度的变化估算的热力学参数告诉我们,在低温下,四甲基全氟壬酸铵(C(8)F(17)COON(CH(3))(4),PFNT)在离子液体(ILs)中的胶束形成是熵驱动的过程,但在高温下是焓驱动的过程。氟碳表面活性剂在[bmim]BF(4)中胶束化的驱动力是溶剂疏水性,这是由于氟碳链的疏油性和疏油性。