Patel S K, Pankewycz O G, Weber-Shrikant E, Zachariah M, Kohli R, Nader N D, Laftavi M R
Transplantation Surgery, Department of Surgery, University at Buffalo (SUNY), Buffalo, New York, USA.
Transplant Proc. 2012 Sep;44(7):2202-6. doi: 10.1016/j.transproceed.2012.07.109.
Pulsatile pump perfusion of potential kidneys for transplantation is known to decrease the rate of delayed graft function (DGF) and improve their 1-year survival. Flow and resistance parameters are often used to determine the suitability of kidneys for transplantation. Kidneys with low flow rates are often subjected to higher pressures to improve flow. This study evaluated the effect of higher pump pressures on posttransplant renal function.
We performed a retrospective analysis of 73 deceased donor kidneys preserved using pump perfusion (LifePort) at our center between May 2006 and September 2009. We calculated the mean pump pressure (MP) for the duration of perfusion of each kidney, using systolic pressure (SP) and diastolic pressure (DP) readings with the following formula: (MP = DP + 1/3 (SP - DP). The kidneys were divided into a low (LP; n = 49) and a high-pressure group (HP; n = 24) based on a MP cutoff value of 23 mm Hg. The two groups were then compared for differences in perfusion dynamics and primary endpoints including DGF and 1-year graft survival. Statistical analysis was performed using paired Student t test and chi-square analysis.
The two groups were comparable for donor age, extended criteria, sensitization, and cold ischemic times. They differed significantly in higher initial (0.65 ± 0.4 versus 0.4 ± 0.2, P = .01), average (0.25 ± 0.08 versus 0.18 ± 0.06, P = .0006), and terminal resistance (0.21 ± 0.07 versus 0.17 ± 0.06, P = .008) of HP versus LP kidneys. Flow rates were comparable between the two groups. DGF was higher in HP kidneys (75% versus 40%, P = .006) with similar 1-year graft survival (87.5% versus 89%, P = .7).
Perfusate flow through a kidney can be improved by increasing pressure settings to overcome elevated resistance. This maneuver was not associated with a lower rate of DGF after transplantation. One-year graft survival remained unaffected.
已知对潜在的移植肾进行搏动泵灌注可降低移植肾功能延迟(DGF)的发生率并提高其1年生存率。流量和阻力参数常被用于确定肾脏是否适合移植。流量低的肾脏通常会承受更高的压力以改善血流。本研究评估了更高的泵压力对移植后肾功能的影响。
我们对2006年5月至2009年9月期间在本中心使用泵灌注(LifePort)保存的73个已故供体肾脏进行了回顾性分析。我们使用收缩压(SP)和舒张压(DP)读数,通过以下公式计算每个肾脏灌注期间的平均泵压力(MP):(MP = DP + 1/3(SP - DP))。根据MP截止值23 mmHg,将肾脏分为低压组(LP;n = 49)和高压组(HP;n = 24)。然后比较两组在灌注动力学和主要终点(包括DGF和1年移植肾存活率)方面的差异。使用配对学生t检验和卡方分析进行统计分析。
两组在供体年龄、扩展标准、致敏情况和冷缺血时间方面具有可比性。HP组与LP组肾脏相比,初始阻力(0.65±0.4对0.4±0.2,P = 0.01)、平均阻力(0.25±0.08对0.18±0.06,P = 0.0006)和终末阻力(0.21±0.07对0.17±0.06,P = 0.008)存在显著差异。两组间流量相当。HP组肾脏的DGF更高(75%对40%,P = 0.006),而1年移植肾存活率相似(87.5%对89%,P = 0.7)。
通过增加压力设置可克服升高的阻力,从而改善通过肾脏的灌注液流量。此操作与移植后较低的DGF发生率无关。1年移植肾存活率不受影响。