Department of Chemistry and Biochemistry, University of North Carolina Wilmington, Wilmington, North Carolina 28403, United States.
Inorg Chem. 2013 Jan 7;52(1):15-27. doi: 10.1021/ic3002509. Epub 2012 Dec 11.
Some metal ion complexing properties of DPP (2,9-Di(pyrid-2-yl)-1,10-phenanthroline) are reported with a variety of Ln(III) (Lanthanide(III)) ions and alkali earth metal ions, as well as the uranyl(VI) cation. The intense π-π* transitions in the absorption spectra of aqueous solutions of 10(-5) M DPP were monitored as a function of pH and metal ion concentration to determine formation constants of the alkali-earth metal ions and Ln(III) (Ln = lanthanide) ions. It was found that log K(1)(DPP) for the Ln(III) ions has a peak at Ln(III) = Sm(III) in a plot of log K(1) versus 1/r(+) (r(+) = ionic radius for 8-coordination). For Ln(III) ions larger than Sm(III), there is a steady rise in log K(1) from La(III) to Sm(III), while for Ln(III) ions smaller than Sm(III), log K(1) decreases slightly to the smallest Ln(III) ion, Lu(III). This pattern of variation of log K(1) with varying size of Ln(III) ion was analyzed using MM (molecular mechanics) and DFT (density functional theory) calculations. Values of strain energy (∑U) were calculated for the Ln(DPP)(H(2)O)(5) and Ln(qpy)(H(2)O)(5) (qpy = quaterpyrdine) complexes of all the Ln(III) ions. The ideal M-N bond lengths used for the Ln(III) ions were the average of those found in the CSD (Cambridge Structural Database) for the complexes of each of the Ln(III) ions with polypyridyl ligands. Similarly, the ideal M-O bond lengths were those for complexes of the Ln(III) ions with coordinated aqua ligands in the CSD. The MM calculations suggested that in a plot of ∑U versus ideal M-N length, a minimum in ∑U occurred at Pm(III), adjacent in the series to Sm(III). The significance of this result is that (1) MM calculations suggest that a similar metal ion size preference will occur for all polypyridyl-type ligands, including those containing triazine groups, that are being developed as solvent extractants in the separation of Am(III) and Ln(III) ions in the treatment of nuclear waste, and (2) Am(III) is very close in M-N bond lengths to Pm(III), so that an important aspect of the selectivity of polypyridyl type ligands for Am(III) will depend on the above metal ion size-based selectivity. The selectivity patterns of DPP with the alkali-earth metal ions shows a similar preference for Ca(II), which has the most appropriate M-N lengths. The structures of DPP complexes of Zn(II) and Bi(III), as representative of a small and of a large metal ion respectively, are reported. Zn(DPP)(2)(2) (triclinic, P1, R = 0.0507) has a six-coordinate Zn(II), with each of the two DPP ligands having one noncoordinated pyridyl group appearing to be π-stacked on the central aromatic ring of the other DPP ligand. Bi(DPP)(H(2)O)(2)(ClO(4))(2) (triclinic, P1, R = 0.0709) has an eight-coordinate Bi, with the coordination sphere composed of the four N donors of the DPP ligand, two coordinated water molecules, and the O donors of two unidentate perchlorates. As is usually the case with Bi(III), there is a gap in the coordination sphere that appears to be the position of a lone pair of electrons on the other side of the Bi from the DPP ligand. The Bi-L bonds become relatively longer as one moves from the side of the Bi containg the DPP to the side where the lone pair is thought to be situated. A DFT analysis of Ln(tpy)(H(2)O)(n) and Ln(DPP)(H(2)O)(5) complexes is reported. The structures predicted by DFT are shown to match very well with the literature crystal structures for the Ln(tpy)(H(2)O)(n) with Ln = La and n = 6, and Ln = Lu with n = 5. This then gives one confidence that the structures for the DPP complexes generated by DFT are accurate. The structures generated by DFT for the Ln(DPP)(H(2)O)(5) complexes are shown to agree very well with those generated by MM, giving one confidence in the accuracy of the latter. An analysis of the DFT and MM structures shows the decreasing O--O nonbonded distances as one progresses from La to Lu, with these distances being much less than the sum of the van der Waals radii for the smaller Ln(III) ions. The effect that such short O--O nonbonded distances has on thermodynamic complex stability and coordination number is then discussed.
一些 DPP(2,9-二(吡啶-2-基)-1,10-菲咯啉)与各种 Ln(III)(镧系元素(III))离子和碱土金属离子以及铀酰(VI)阳离子的金属离子络合性质已经被报道。在水溶液中,将 10(-5)M DPP 的吸收光谱的π-π*跃迁作为 pH 和金属离子浓度的函数进行监测,以确定碱土金属离子和 Ln(III)(Ln=镧系元素)离子的形成常数。发现对于 Ln(III)离子,log K(1)(DPP)在 Ln(III)= Sm(III)处达到峰值,在 log K(1)与 1/r(+)(r(+)= 8 配位的离子半径)的图中。对于大于 Sm(III)的 Ln(III)离子,log K(1)从 La(III)到 Sm(III)稳步上升,而对于小于 Sm(III)的 Ln(III)离子,log K(1)略有下降到最小的 Ln(III)离子 Lu(III)。这种随 Ln(III)离子尺寸变化的 log K(1)变化模式使用 MM(分子力学)和 DFT(密度泛函理论)计算进行了分析。为所有 Ln(III)离子的[Ln(DPP)(H2O)(5)](3+)和[Ln(qpy)(H2O)(5)](3+)(qpy=四吡啶)络合物计算了应变能(∑U)的值。Ln(III)离子理想的 M-N 键长使用 CSD(剑桥结构数据库)中每个 Ln(III)离子与多吡啶配体形成的复合物的平均键长。类似地,理想的 M-O 键长是 CSD 中与配位水合配体形成的 Ln(III)离子的键长。MM 计算表明,在∑U 与理想 M-N 长度的图中,在 Pm(III)处出现∑U 的最小值,Pm(III)在该系列中与 Sm(III)相邻。这一结果的意义在于:(1)MM 计算表明,对于所有包含三嗪基团的多吡啶型配体,包括正在开发为 Am(III)和 Ln(III)离子分离溶剂萃取剂的配体,都将发生类似的金属离子尺寸偏好,在核废料处理中,(2)Am(III)与 Pm(III)在 M-N 键长度上非常接近,因此多吡啶型配体对 Am(III)的选择性的一个重要方面将取决于基于上述金属离子尺寸的选择性。DPP 与碱土金属离子的选择性模式表现出对 Ca(II)的类似偏好,Ca(II)具有最合适的 M-N 长度。报道了 Zn(II)和 Bi(III)的 DPP 配合物的结构,分别代表小金属离子和大金属离子。[Zn(DPP)(2)](ClO4)(2)(三斜晶系,P1,R = 0.0507)具有六配位的 Zn(II),每个 DPP 配体有一个未配位的吡啶基团,似乎堆叠在另一个 DPP 配体的中心芳环上。[Bi(DPP)(H2O)(2)(ClO4)(2)](ClO4)(三斜晶系,P1,R = 0.0709)具有八配位的 Bi,配位球由 DPP 配体的四个 N 供体、两个配位的水分子和两个未配位的高氯酸根的 O 供体组成。与通常的 Bi(III)情况一样,在配位球中存在一个间隙,似乎是来自 DPP 配体的 Bi 另一侧的孤对电子的位置。随着 Bi 上的孤对电子从含有 DPP 的一侧向认为孤对电子所在的另一侧移动,Bi-L 键变得相对更长。报道了[Ln(tpy)(H2O)(n)](3+)和[Ln(DPP)(H2O)(5)](3+)络合物的 DFT 分析。通过 DFT 预测的结构与文献中 Ln = La 和 n = 6 的[Ln(tpy)(H2O)(n)](3+)以及 Ln = Lu 和 n = 5 的[Ln(DPP)(H2O)(5)](3+)的晶体结构非常吻合。这使人们对 DFT 生成的 DPP 配合物结构的准确性有了信心。DFT 生成的[Ln(DPP)(H2O)(5)](3+)配合物的结构与 MM 生成的结构非常吻合,这使人们对后者的准确性有了信心。对 DFT 和 MM 结构的分析表明,随着从 La 到 Lu 的进展,O-O 非键距逐渐减小,这些距离远小于较小的 Ln(III)离子的范德华半径之和。然后讨论了这种短 O-O 非键距对热力学配合物稳定性和配位数的影响。