Lee Arthur T, Williams Ariel A, Lee Julia, Cheng Robert, Lindsey Derek P, Ladd Amy L
Department of Orthopaedic Surgery, Robert A Chase Hand and Upper Limb Center, Stanford University School of Medicine, Stanford, CA 94304, USA.
J Hand Surg Am. 2013 Feb;38(2):309-15. doi: 10.1016/j.jhsa.2012.10.038. Epub 2012 Dec 23.
In thumb carpometacarpal osteoarthritis, current evidence suggests that degenerative, bony remodeling primarily occurs within the trapezium. Nevertheless, the pathomechanics involved and the most common sites of wear remain controversial. Quantifying structural bone morphology characteristics with high-resolution computed tomography CT (micro-CT) infer regions of load transmission. Using micro-CT, we investigated whether predominant trabecular patterns exist in arthritic versus normal trapeziums.
We performed micro-CT analysis on 13 normal cadaveric trapeziums and 16 Eaton stage III to IV trapeziums. We computationally divided each specimen into 4 quadrants: volar-ulnar, volar-radial, dorsal-radial, and dorsal-ulnar. Measurements of trabecular bone morphologic parameters included bone volume ratio, connectivity, trabecular number, and trabecular thickness. Using analysis of variance with post hoc Bonferroni/Dunn correction, we compared osteoarthritic and normal specimen quadrant measurements.
No significant difference existed in bone volume fraction between the osteoarthritic and normal specimens. Osteoarthritic trapeziums, however, demonstrated significantly higher trabecular number and connectivity than nonosteoarthritic trapeziums. Comparing the volar-ulnar quadrant of osteoarthritis and normal specimens collectively, this quadrant in both consistently possessed significantly higher bone volume fraction, trabecular number, and connectivity than the dorsal-radial and volar-radial quadrants.
The significantly greater trabecular bone volume, thickness, and connectivity in the volar-ulnar quadrant compared with the dorsal-radial and dorsal-ulnar quadrants provides evidence that the greatest compressive loads at the first carpometacarpal joint occur at the volar-ulnar quadrant of the trapezium, representing a consistently affected region of wear in both normal and arthritic states.
These findings suggest that trapezial trabecular morphology undergoes pathologic alteration. This provides indirect evidence that changes in load transmission occur with thumb carpometacarpal joint arthritis development.
在拇指腕掌关节骨关节炎中,目前的证据表明,退行性骨质重塑主要发生在大多角骨内。然而,所涉及的病理力学以及最常见的磨损部位仍存在争议。利用高分辨率计算机断层扫描(CT)(显微CT)量化骨结构形态特征可推断负荷传递区域。我们使用显微CT研究了患有关节炎的大多角骨与正常大多角骨中是否存在主要的小梁模式。
我们对13个正常尸体的大多角骨和16个伊顿III至IV期的大多角骨进行了显微CT分析。我们通过计算将每个标本分为4个象限:掌尺侧、掌桡侧、背桡侧和背尺侧。小梁骨形态学参数的测量包括骨体积比、连通性、小梁数量和小梁厚度。我们使用方差分析并进行事后Bonferroni/Dunn校正,比较了骨关节炎标本和正常标本象限的测量结果。
骨关节炎标本和正常标本之间的骨体积分数没有显著差异。然而,患有关节炎的大多角骨的小梁数量和连通性明显高于未患骨关节炎的大多角骨。总体比较骨关节炎标本和正常标本的掌尺侧象限,这两个象限的骨体积分数、小梁数量和连通性始终明显高于背桡侧和掌桡侧象限。
与背桡侧和背尺侧象限相比,掌尺侧象限小梁骨体积、厚度和连通性明显更大,这证明第一腕掌关节最大的压缩负荷出现在大多角骨的掌尺侧象限,这是正常和关节炎状态下持续受到磨损影响的区域。
这些发现表明大多角骨小梁形态发生了病理改变。这提供了间接证据,表明随着拇指腕掌关节关节炎的发展,负荷传递发生了变化。