Walker Andrew M, Johnston Clifton R, Rival David E
Department of Mechanical and Manufacturing Engineering, University of Calgary, 2500 University Drive N.W., Calgary, AB T2N 1N4, Canada.
J Biomech Eng. 2012 Nov;134(11):111001. doi: 10.1115/1.4007746.
Although deployed in the vasculature to expand vessel diameter and improve blood flow, protruding stent struts can create complex flow environments associated with flow separation and oscillating shear gradients. Given the association between magnitude and direction of wall shear stress (WSS) and endothelial phenotype expression, accurate representation of stent-induced flow patterns is critical if we are to predict sites susceptible to intimal hyperplasia. Despite the number of stents approved for clinical use, quantification on the alteration of hemodynamic flow parameters associated with the Gianturco Z-stent is limited in the literature. In using experimental and computational models to quantify strut-induced flow, the majority of past work has assumed blood or representative analogs to behave as Newtonian fluids. However, recent studies have challenged the validity of this assumption. We present here the experimental quantification of flow through a Gianturco Z-stent wire in representative Newtonian and non-Newtonian blood analog environments using particle image velocimetry (PIV). Fluid analogs were circulated through a closed flow loop at physiologically appropriate flow rates whereupon PIV snapshots were acquired downstream of the wire housed in an acrylic tube with a diameter characteristic of the carotid artery. Hemodynamic parameters including WSS, oscillatory shear index (OSI), and Reynolds shear stresses (RSS) were measured. Our findings show that the introduction of the stent wire altered downstream hemodynamic parameters through a reduction in WSS and increases in OSI and RSS from nonstented flow. The Newtonian analog solution of glycerol and water underestimated WSS while increasing the spatial coverage of flow reversal and oscillatory shear compared to a non-Newtonian fluid of glycerol, water, and xanthan gum. Peak RSS were increased with the Newtonian fluid, although peak values were similar upon a doubling of flow rate. The introduction of the stent wire promoted the development of flow patterns that are susceptible to intimal hyperplasia using both Newtonian and non-Newtonian analogs, although the magnitude of sites affected downstream was appreciably related to the rheological behavior of the analog. While the assumption of linear viscous behavior is often appropriate in quantifying flow in the largest arteries of the vasculature, the results presented here suggest this assumption overestimates sites susceptible to hyperplasia and restenosis in flow characterized by low and oscillatory shear.
尽管血管支架用于扩张血管直径并改善血流,但突出的支架支柱会产生与血流分离和振荡剪切梯度相关的复杂血流环境。鉴于壁面剪应力(WSS)的大小和方向与内皮细胞表型表达之间的关联,如果我们要预测易发生内膜增生的部位,准确呈现支架诱导的血流模式至关重要。尽管有多种支架已获批用于临床,但关于与Gianturco Z形支架相关的血流动力学参数改变的量化研究在文献中有限。在使用实验和计算模型量化支柱诱导的血流时,过去的大多数工作都假定血液或代表性模拟物表现为牛顿流体。然而,最近的研究对这一假设的有效性提出了质疑。我们在此展示了使用粒子图像测速技术(PIV)在代表性牛顿流体和非牛顿血液模拟环境中对通过Gianturco Z形支架金属丝的血流进行实验量化的结果。流体模拟物以生理合适的流速在封闭的血流回路中循环,然后在置于具有颈动脉特征直径的丙烯酸管中的金属丝下游获取PIV快照。测量了包括WSS、振荡剪切指数(OSI)和雷诺剪切应力(RSS)在内的血流动力学参数。我们的研究结果表明,支架金属丝的引入通过降低WSS以及增加OSI和RSS(相对于无支架血流)改变了下游血流动力学参数。与甘油、水和黄原胶的非牛顿流体相比,甘油和水的牛顿模拟溶液低估了WSS,同时增加了血流逆转和振荡剪切的空间范围。牛顿流体使峰值RSS增加,尽管流速加倍时峰值相似。支架金属丝的引入促进了使用牛顿和非牛顿模拟物时易发生内膜增生的血流模式的发展,尽管下游受影响部位的程度与模拟物的流变行为明显相关。虽然线性粘性行为的假设在量化血管系统中最大动脉的血流时通常是合适的,但此处给出的结果表明,在以低剪切和振荡剪切为特征的血流中,这一假设高估了易发生增生和再狭窄的部位。