Suppr超能文献

硅基光子晶体腔上的钇-铒二硅酸盐薄膜中增强的1.54μm发射。

Enhanced 1.54 μm emission in Y-Er disilicate thin films on silicon photonic crystal cavities.

作者信息

Lo Savio R, Miritello M, Shakoor A, Cardile P, Welna K, Andreani L C, Gerace D, Krauss T F, O'Faolain L, Priolo F, Galli M

机构信息

Dipartimento di Fisica, Università di Pavia, Via Bassi 6, 27100 Pavia, Italy.

出版信息

Opt Express. 2013 Apr 22;21(8):10278-88. doi: 10.1364/OE.21.010278.

Abstract

We introduce an Y-Er disilicate thin film deposited on top of a silicon photonic crystal cavity as a gain medium for active silicon photonic devices. Using photoluminescence analysis, we demonstrate that Er luminescence at 1.54 μm is enhanced by coupling with the cavity modes, and that the directionality of the Er optical emission can be controlled through far-field optimization of the cavity. We determine the maximum excitation power that can be coupled into the cavity to be 12 mW, which is limited by free carrier absorption and thermal heating. At maximum excitation, we observe that nearly 30% of the Er population is in the excited state, as estimated from the direct measurement of the emitted power. Finally, using time-resolved photoluminescence measurements, we determine a value of 2.3 for the Purcell factor of the system at room temperature. These results indicate that overcoating a silicon photonic nanostructure with an Er-rich dielectric layer is a promising method for achieving light emission at 1.54 µm wavelength on a silicon platform.

摘要

我们介绍了一种沉积在硅光子晶体腔顶部的钇铒二硅酸盐薄膜,作为有源硅光子器件的增益介质。通过光致发光分析,我们证明了1.54μm处的铒发光通过与腔模耦合得到增强,并且铒光发射的方向性可以通过腔的远场优化来控制。我们确定可以耦合到腔中的最大激发功率为12mW,这受到自由载流子吸收和热加热的限制。在最大激发时,根据发射功率的直接测量估计,我们观察到近30%的铒粒子处于激发态。最后,通过时间分辨光致发光测量,我们确定了该系统在室温下的珀塞尔因子值为2.3。这些结果表明,用富含铒的介电层覆盖硅光子纳米结构是在硅平台上实现1.54μm波长发光的一种有前途的方法。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验