Department of Electrical and Computer Engineering, University of Illinois, Urbana-Champaign, IL 61822, USA.
Ultrasonics. 2013 Sep;53(7):1293-303. doi: 10.1016/j.ultras.2013.03.014. Epub 2013 Apr 16.
During application of high intensity focused ultrasound (HIFU) with therapy arrays, the existence of grating lobes can cause heating at unintended tissue regions. Therefore, the reduction of grating lobes in therapeutic arrays is an important goal. One way to reduce the grating lobes in therapy arrays is to excite the arrays with broadband signals (defined here as >10% fractional bandwidth). To achieve a reduction in grating lobe levels in an ultrasonic array, coded waveforms can be utilized that reduce the grating lobe levels while maintaining the spatial peak temporal average intensity. In this study, a 5-MHz, 9-element, 1.25 mm inter-elemental spacing linear array was excited by a sinusoidal waveform, a conventional linear chirp, and a modified linear chirp. Both chirps spanned the -3-dB bandwidth of the transducer. The conventional chirp was a broadband signal with a linear sweep of frequencies between 2.5 and 7.5 MHz, with all frequency components excited with equal amplitude. The modified chirp signal also swept the frequencies between 2.5 and 7.5 MHz, but the amplitude was weighted such that the edges (low and high frequencies of the band) were excited with more energy than the center of the band. In simulations, the field patterns for the sinusoidal, conventional chirp and modified chirp excitations were produced from the array using Field II and compared. For experiments, the beam pattern from a 5-MHz single-element transducer was mapped using a hydrophone for the sinusoidal, conventional chirp and modified chirp excitation. Each field from the transducer was repeated and summed to produce a field from an array of 9 elements. The difference in the time averaged intensity (in dB) in the main lobe and grating lobes were estimated for each excitation and compared. The results demonstrated that the chirp signals resulted in decreases in grating lobe levels compared to the main lobe, i.e. 10 dB down for focusing and 6 dB down for focusing and steering. A further 1 dB decrease in grating lobe levels was observed for the modified chirp excitation compared to the conventional chirp excitation, which corresponds to ~21% reduction in energy deposition at the grating lobe location.
在高强度聚焦超声(HIFU)治疗阵列的应用中,栅瓣的存在会导致非预期组织区域的加热。因此,减少治疗阵列中的栅瓣是一个重要的目标。减少治疗阵列中的栅瓣的一种方法是用宽带信号(这里定义为> 10%的分数带宽)激励阵列。为了降低超声阵列中的栅瓣电平,可以利用编码波形来降低栅瓣电平,同时保持空间峰值时间平均强度。在这项研究中,一个 5MHz、9 个元件、1.25mm 元件间距的线性阵列被正弦波、常规线性线性调频和改进线性线性调频激励。两种线性调频都跨越了换能器的-3dB 带宽。常规线性调频是一种宽带信号,频率在 2.5MHz 到 7.5MHz 之间线性扫描,所有频率分量的激励幅度相等。改进的线性调频信号也在 2.5MHz 到 7.5MHz 之间扫描频率,但幅度加权使边缘(带宽的低和高频)的能量比带宽中心的能量更大。在模拟中,使用 Field II 从阵列产生正弦、常规线性调频和改进线性调频激励的场模式,并进行比较。在实验中,使用水听器映射 5MHz 单元件换能器的波束图案,用于正弦、常规线性调频和改进线性调频激励。重复并求和每个换能器的场以产生 9 个元件的阵列的场。估计每种激励的主瓣和栅瓣的时间平均强度(dB)的差异,并进行比较。结果表明,与主瓣相比,线性调频信号导致栅瓣电平降低,即聚焦时降低 10dB,聚焦和转向时降低 6dB。与常规线性调频激励相比,改进的线性调频激励的栅瓣电平进一步降低了 1dB,这对应于栅瓣位置能量沉积减少约 21%。