Suppr超能文献

外壳成分对微泡造影剂共振频率的影响。

Influence of shell composition on the resonance frequency of microbubble contrast agents.

机构信息

Department of Chemical Engineering, Drexel University, Philadelphia, PA, USA.

出版信息

Ultrasound Med Biol. 2013 Jul;39(7):1292-302. doi: 10.1016/j.ultrasmedbio.2013.02.462. Epub 2013 May 15.

Abstract

The effect of variations in microbubble shell composition on microbubble resonance frequency is revealed through experiment. These variations are achieved by altering the mole fraction and molecular weight of functionalized polyethylene glycol (PEG) in the microbubble phospholipid monolayer shell and measuring the microbubble resonance frequency. The resonance frequency is measured via a chirp pulse and identified as the frequency at which the pressure amplitude loss of the ultrasound wave is the greatest as a result of passing through a population of microbubbles. For the shell compositions used herein, we find that PEG molecular weight has little to no influence on resonance frequency at an overall PEG mole fraction (0.01) corresponding to a mushroom regime and influences the resonance frequency markedly at overall PEG mole fractions (0.050-0.100) corresponding to a brush regime. Specifically, the measured resonance frequency was found to be 8.4, 4.9, 3.3 and 1.4 MHz at PEG molecular weights of 1000, 2000, 3000 and 5000 g/mol, respectively, at an overall PEG mole fraction of 0.075. At an overall PEG mole fraction of just 0.01, on the other hand, resonance frequency exhibited no systematic variation, with values ranging from 5.7 to 4.9 MHz. Experimental results were analyzed using the Sarkar bubble dynamics model. With the dilatational viscosity held constant (10(-8) N·s/m) and the elastic modulus used as a fitting parameter, model fits to the pressure amplitude loss data resulted in elastic modulus values of 2.2, 2.4, 1.6 and 1.8 N/m for PEG molecular weights of 1000, 2000, 3000 and 5000 g/mol, respectively, at an overall PEG mole fraction of 0.010 and 4.2, 1.4, 0.5 and 0.0 N/m, respectively, at an overall PEG mole fraction of 0.075. These results are consistent with theory, which predicts that the elastic modulus is constant in the mushroom regime and decreases with PEG molecular weight to the inverse 3/5 power in the brush regime. Additionally, these results are consistent with inertial cavitation studies, which revealed that increasing PEG molecular weight has little to no effect on inethe rtial cavitation threshold in the mushroom regime, but that increasing PEG molecular weight decreases inertial cavitation markedly in the brush regime. We conclude that the design and synthesis of microbubbles with a prescribed resonance frequency is attainable by tuning PEG composition and molecular weight.

摘要

通过实验揭示了微泡壳成分的变化对微泡共振频率的影响。这些变化是通过改变功能性聚乙二醇(PEG)在微泡磷脂单层壳中的摩尔分数和分子量来实现的,并测量微泡的共振频率。共振频率通过啁啾脉冲测量,并被确定为当超声波通过微泡群时压力幅度损失最大的频率。对于本文中使用的壳成分,我们发现,在整体 PEG 摩尔分数(0.01)对应于蘑菇状态的情况下,PEG 分子量对共振频率几乎没有影响,而在整体 PEG 摩尔分数(0.050-0.100)对应于刷状态的情况下,PEG 分子量对共振频率有显著影响。具体来说,在整体 PEG 摩尔分数为 0.075 的情况下,PEG 分子量分别为 1000、2000、3000 和 5000 g/mol 时,测量到的共振频率分别为 8.4、4.9、3.3 和 1.4 MHz。另一方面,在整体 PEG 摩尔分数仅为 0.01 的情况下,共振频率没有表现出系统的变化,其值范围为 5.7 至 4.9 MHz。使用 Sarkar 气泡动力学模型对实验结果进行了分析。在保持拉伸粘度为常数(10^-8 N·s/m)并将弹性模量用作拟合参数的情况下,对压力幅度损失数据的模型拟合导致在整体 PEG 摩尔分数为 0.010 时,PEG 分子量分别为 1000、2000、3000 和 5000 g/mol 时的弹性模量值分别为 2.2、2.4、1.6 和 1.8 N/m,以及在整体 PEG 摩尔分数为 0.075 时,PEG 分子量分别为 4.2、1.4、0.5 和 0.0 N/m。这些结果与理论一致,理论预测在蘑菇状态下弹性模量是恒定的,而在刷状态下,弹性模量随 PEG 分子量的增加以 3/5 的反比减小。此外,这些结果与惯性空化研究一致,该研究表明,增加 PEG 分子量对蘑菇状态下的惯性空化阈值几乎没有影响,但在刷状态下,增加 PEG 分子量会显著降低惯性空化。我们得出结论,通过调整 PEG 组成和分子量,可以实现具有规定共振频率的微泡的设计和合成。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验