Toyota Motor Corporation, 1 Toyota-cho, Toyota, Aichi, Japan.
Traffic Inj Prev. 2013;14 Suppl:S64-76. doi: 10.1080/15389588.2013.796373.
This article describes the chest injury risk reduction effect of shoulder restraints using finite element (FE) models of the worldwide harmonized side impact dummy (WorldSID) and Total Human Model for Safety (THUMS) in an FE model 32 km/h oblique pole side impact.
This research used an FE model of a mid-sized vehicle equipped with various combinations of curtain shield air bags, torso air bags, and shoulder restraint air bags. As occupant models, AM50 WorldSID and THUMS AM50 Version 4 were used for comparison.
The research investigated the effect of shoulder restraint air bag on chest injury by comparing cases with and without a shoulder side air bag. The maximum external force to the chest was reduced by shoulder restraint air bag in both WorldSID and THUMS, reducing chest injury risk as measured by the amount of rib deflection, number of the rib fractures, and rib deflection ratio. However, it was also determined that the external force to shoulder should be limited to the chest injury threshold because the external shoulder force transmits to the chest via the arm in the case of WorldSID and via the scapula in the case of THUMS. Because these results show the shoulder restraint air bag effect on chest injury risk, the vent hole size of the shoulder restraint air bag was changed for varying reaction forces to investigate the relationship between the external force to the shoulder and the risk of chest injury. In the case of THUMS, an external shoulder force of 1.8 kN and more force from the shoulder restraint air bag was necessary to help prevent rib fracture. Increasing external force applied to shoulder up to 6.2 kN (the maximum force used in this study) did not induce any rib or clavicle fractures in the THUMS. When the shoulder restraint air bag generated external force to the shoulder from 1.8 to 6.2 kN in THUMS, which were applied to the WorldSID, the shoulder deflection ranged from 35 to 68 mm, and the shoulder force ranged from 1.8 to 2.3 kN.
In the test configuration used, a shoulder restraint using the air bag helps reduce chest injury risk by lowering the maximum magnitude of external force to the shoulder and chest. To help reduce rib fracture risk in the THUMS, the shoulder restraint air bag was expected to generate a force of 3.7 kN with a minimum rib deflection ratio. This corresponds to a shoulder rib deflection of 60 mm and a shoulder load of 2.2 kN in WorldSID. Supplemental materials are available for this article. Go to the publisher's online edition of Traffic Injury Prevention to view the supplemental file.
本文通过 32km/h 斜置杆侧面碰撞的有限元(FE)模型,描述了全球协调侧碰撞假人(WorldSID)和全尺寸人体模型用于安全(THUMS)的肩部约束在降低胸部损伤风险方面的效果。
本研究使用了配备各种帘式安全气囊、躯干安全气囊和肩部约束安全气囊组合的中型车辆的 FE 模型。作为乘员模型,使用了 AM50 WorldSID 和 THUMS AM50 版本 4 进行比较。
本研究通过比较有和没有肩部侧气囊的情况,研究了肩部约束气囊对胸部损伤的影响。在 WorldSID 和 THUMS 中,肩部约束气囊均降低了胸部的最大外力,从而降低了肋骨偏移量、肋骨骨折数量和肋骨偏移比所衡量的胸部损伤风险。然而,也确定了肩部外部力应限制在胸部损伤阈值以下,因为在 WorldSID 中,肩部外部力通过手臂传递到胸部,而在 THUMS 中,肩部外部力通过肩胛骨传递到胸部。由于这些结果表明肩部约束气囊对胸部损伤风险的影响,因此改变了肩部约束气囊的通风孔尺寸,以研究肩部外部力与胸部损伤风险之间的关系。在 THUMS 中,需要 1.8kN 以上的肩部约束气囊外部力来帮助防止肋骨骨折。在 THUMS 中,将施加到肩部的外部力增加到 6.2kN(本研究中使用的最大力)不会导致任何肋骨或锁骨骨折。当肩部约束气囊在 THUMS 中向肩部施加 1.8 到 6.2kN 的外力时,这些力应用于 WorldSID,肩部的偏移范围从 35 到 68mm,肩部力从 1.8 到 2.3kN。
在使用的测试配置中,使用气囊的肩部约束有助于通过降低肩部和胸部的最大外力来降低胸部损伤风险。为了降低 THUMS 中的肋骨骨折风险,肩部约束气囊预计将产生 3.7kN 的力,最小肋骨偏移比为 0.37。这对应于 WorldSID 中 60mm 的肩部肋骨偏移和 2.2kN 的肩部负荷。本文提供了补充材料。请访问出版商的《交通伤害预防》在线版查看补充文件。