School of Health Sciences, University of Ballarat, Mount Helen, VIC 3350, Australia.
Food Chem. 2014 Jan 15;143:484-91. doi: 10.1016/j.foodchem.2013.07.130. Epub 2013 Aug 8.
The objectives of this study were to quantify the relationship between secondary structure of gelatin and its adsorption at the fish-oil/water interface and to quantify the implication of the adsorption on the dynamic interfacial tension (DST) and emulsion stability. The surface hydrophobicity of the gelatin solutions decreased when the pH increased from 4.0 to 6.0, while opposite tend was observed in the viscosity of the solution. The DST values decreased as the pH increased from 4.0 to 6.0, indicating that higher positive charges (measured trough zeta potential) in the gelatin solution tended to result in higher DST values. The adsorption kinetics of the gelatin solution was examined through the calculated diffusion coefficients (Deff). The addition of acid promoted the random coil and β-turn structures at the expense of α-helical structure. The addition of NaOH decreased the β-turn and increased the α-helix and random coil. The decrease in the random coil and triple helix structures in the gelatin solution resulted into increased Deff values. The highest diffusion coefficients, the highest emulsion stability and the lowest amount of random coil and triple helix structures were observed at pH=4.8. The lowest amount of random coil and triple helix structures in the interfacial protein layer correlated with the highest stability of the emulsion (highest ESI value). The lower amount of random coil and triple helix structures allowed higher coverage of the oil-water interface by relatively highly ordered secondary structure of gelatin.
本研究的目的是量化明胶的二级结构与其在鱼油/水界面吸附之间的关系,并量化吸附对动态界面张力(DST)和乳液稳定性的影响。当 pH 值从 4.0 增加到 6.0 时,明胶溶液的表面疏水性降低,而溶液的粘度则呈现相反的趋势。随着 pH 值从 4.0 增加到 6.0,DST 值降低,这表明明胶溶液中带更多正电荷(通过 zeta 电位测量)倾向于产生更高的 DST 值。通过计算扩散系数(Deff)来检查明胶溶液的吸附动力学。添加酸会促进无规卷曲和β-转角结构的形成,而牺牲α-螺旋结构。添加 NaOH 会降低β-转角并增加α-螺旋和无规卷曲。明胶溶液中无规卷曲和三螺旋结构的减少导致 Deff 值增加。在 pH=4.8 时,观察到最高的扩散系数、最高的乳液稳定性和最低的无规卷曲和三螺旋结构含量。界面蛋白层中无规卷曲和三螺旋结构含量最低与乳液稳定性最高(ESI 值最高)相关。无规卷曲和三螺旋结构含量较低,允许明胶相对高度有序的二级结构更有效地覆盖油水界面。