Fremantle Hospital Orthopaedic Unit, Fremantle Hospital, Level 6, B Block, Alma Street, Fremantle, Western Australia 6160, Australia.
J Orthop Surg Res. 2013 Oct 17;8:35. doi: 10.1186/1749-799X-8-35.
Unstable proximal femoral fractures are common and challenging for the orthopaedic surgeon. Often, these are treated with intramedullary nails. The most common mode of failure of any device to treat these fractures is cut-out. The Synthes proximal femoral nail antirotation (PFNA) is unique because it is the only proximal femoral intramedullary nail which employs a helical blade in lieu of a lag screw. The optimal tip-apex distance is 25 mm or less for a dynamic hip screw. The optimal blade tip placement is not known for the PFNA.
The aim of this study is to determine if the traditional tip-apex distance rule (<25 mm) applies to the PFNA.
A retrospective study of all proximal femoral fractures treated with the PFNA in Western Australian public teaching hospitals between August 2006 and October 2007 was performed. Cases were identified from company and theatre implant use records. Patient demographic data was obtained from hospital records. Fractures were classified according to Arbeitsgemeinschaft für Osteosynthesefragen/Association for the Study of Internal Fixation. Fracture reduction, distal locking type and blade position within the head (tip-apex distance and Cleveland zone) were recorded from the intraoperative and immediate postoperative radiographs. Postoperative radiographs obtained in the routine treatment of patients were studied for review looking primarily for cut-out. Clinical outcomes were measured with the Oxford hip score.
One hundred eighty-eight PFNAs were implanted during the study period, with 178 cases included in this study. Ninety-seven patients could be followed up clinically. There were 18 surgical implant-related failures (19%). The single most common mode of failure was cut-out in six cases (6.2%). Three cut-outs (two medial perforation and one varus collapse) occurred with tip-apex distance (TAD) less than 20 mm. There was no cut-out in cases where the TAD was from 20-30 mm. There were three implant-related failures (nail fracture, missed nail and loose locking screw), four implant-related femoral fractures, two non-unions, two delayed unions and one loss of reduction.
The PFNA is a suitable fixation device for the treatment of unstable proximal femoral fractures. There were still a relatively large number of cut-outs, and the tip-apex distance in the failures showed a bimodal distribution, not like previously demonstrated with dynamic hip screw. We propose that the helical blade behaves differently to a screw, and placement too close to the subchondral bone may lead to penetration through the head.
不稳定型股骨近端骨折较为常见,对骨科医生来说颇具挑战性。此类骨折通常采用髓内钉治疗。任何治疗此类骨折的器械最常见的失效模式是切出。Synthes 股骨近端抗旋髓内钉(PFNA)是独一无二的,因为它是唯一采用螺旋刀片而非拉力螺钉的股骨近端髓内钉。动力髋螺钉的最佳尖端-顶点距离为 25mm 或更小。对于 PFNA,最佳刀片尖端位置尚不清楚。
本研究旨在确定传统的尖端-顶点距离规则(<25mm)是否适用于 PFNA。
对 2006 年 8 月至 2007 年 10 月期间在西澳大利亚州公立教学医院采用 PFNA 治疗的所有股骨近端骨折进行回顾性研究。通过公司和手术室植入物使用记录确定病例。从医院记录中获取患者人口统计学数据。骨折根据 Arbeitsgemeinschaft für Osteosynthesefragen/Association for the Study of Internal Fixation 进行分类。从术中及术后即刻 X 线片记录骨折复位、远端锁定类型和刀片在头内的位置(尖端-顶点距离和克利夫兰区)。对患者常规治疗的术后 X 线片进行研究,主要观察切出情况。采用牛津髋关节评分(Oxford hip score)测量临床结果。
研究期间共植入 188 根 PFNA,其中 178 例纳入本研究。97 例患者可进行临床随访。有 18 例(19%)出现与手术植入物相关的失败。最常见的单一失效模式是 6 例(6.2%)切出。3 例切出(2 例内侧穿孔,1 例内翻塌陷)尖端-顶点距离(TAD)<20mm。TAD 在 20-30mm 之间时无切出。有 3 例与植入物相关的失败(钉断裂、漏钉和锁定螺钉松动)、4 例与植入物相关的股骨骨折、2 例骨不连、2 例延迟愈合和 1 例复位丢失。
PFNA 是治疗不稳定型股骨近端骨折的合适固定装置。仍有相当数量的切出,且失败的尖端-顶点距离呈双峰分布,与动力髋螺钉的表现不同。我们认为,螺旋刀片的行为不同于螺钉,靠近软骨下骨的放置可能导致穿透头部。