School of Mechanical and Aerospace Engineering, Oklahoma State University, 218 Engineering North, Stillwater, OK 74078 5016, United States.
J Biomech. 2014 Feb 7;47(3):723-8. doi: 10.1016/j.jbiomech.2013.11.019. Epub 2013 Nov 25.
The cornea is a highly specialized transparent tissue which covers the front of the eye. It is a tough tissue responsible for refracting the light and protecting the sensitive internal contents of the eye. The biomechanical properties of the cornea are primarily derived from its extracellular matrix, the stroma. The majority of previous studies have used strip tensile and pressure inflation testing methods to determine material parameters of the corneal stroma. Since these techniques do not allow measurements of the shear properties, there is little information available on transverse shear modulus of the cornea. The primary objectives of the present study were to determine the viscoelastic behavior of the corneal stroma in shear and to investigate the effects of the compressive strain. A thorough knowledge of the shear properties is required for developing better material models for corneal biomechanics. In the present study, torsional shear experiments were conducted at different levels of compressive strain (0-30%) on porcine corneal buttons. First, the range of linear viscoelasticity was determined from strain sweep experiments. Then, frequency sweep experiments with a shear strain amplitude of 0.2% (which was within the region of linear viscoelasticity) were performed. The corneal stroma exhibited viscoelastic properties in shear. The shear storage modulus, G', and shear loss modulus, G″, were reported as a function of tissue compression. It was found that although both of these parameters were dependent on frequency, shear strain amplitude, and compressive strain, the average shear storage and loss moduli varied from 2 to 8kPa, and 0.3 to 1.2kPa, respectively. Therefore, it can be concluded that the transverse shear modulus is of the same order of magnitude as the out-of-plane Young's modulus and is about three orders of magnitude lower than the in-plane Young's modulus.
角膜是一种高度特化的透明组织,覆盖在眼睛的前部。它是一种坚韧的组织,负责折射光线并保护眼睛内部敏感的内容物。角膜的生物力学特性主要来自其细胞外基质——基质。先前的大多数研究都使用条状拉伸和压力膨胀测试方法来确定角膜基质的材料参数。由于这些技术不允许测量剪切特性,因此有关角膜横向剪切模量的信息很少。本研究的主要目的是确定角膜基质在剪切中的粘弹性行为,并研究压缩应变的影响。为了开发更好的角膜生物力学材料模型,需要深入了解剪切特性。在本研究中,在不同的压缩应变水平(0-30%)下对猪眼角膜按钮进行了扭转剪切实验。首先,从应变扫掠实验确定线性粘弹性范围。然后,进行剪切应变为 0.2%(处于线性粘弹性范围内)的频率扫掠实验。角膜基质在剪切中表现出粘弹性。报告了剪切储能模量 G'和剪切损耗模量 G"作为组织压缩的函数。结果发现,尽管这两个参数都依赖于频率、剪切应变幅度和压缩应变,但平均剪切储能和损耗模量分别在 2 到 8kPa 之间和 0.3 到 1.2kPa 之间变化。因此,可以得出结论,横向剪切模量与平面外杨氏模量处于同一数量级,并且比平面内杨氏模量低三个数量级。