Suppr超能文献

用于测量颈牙根牙本质通透性的体外模型的开发与验证。

Development and validation of an in vitro model for measurements of cervical root dentine permeability.

作者信息

Jungbluth Holger, Attin Thomas, Buchalla Wolfgang

机构信息

Department of Preventive Dentistry, Periodontology, and Cariology, University of Zürich Center for Dental Medicine, Plattenstrasse 11, 8032, Zürich, Switzerland,

出版信息

Clin Oral Investig. 2014 Dec;18(9):2077-86. doi: 10.1007/s00784-014-1194-5. Epub 2014 Feb 7.

Abstract

OBJECTIVES

The aim of this series of studies was the development and validation of a new model for evaluation of dentinal hypersensitivity (DH) therapies.

MATERIALS AND METHODS

Roots from extracted human teeth were sealed with a flowable composite. In the cervical area, a 3-mm-wide circular window was ground through the seal 1 mm deep into dentine. The pulp lumen was connected to a reservoir of artificial dentinal fluid (ADF) containing protein, mineral salts and methylene blue. At increased pulpal pressure, the ADF released through the said window was collected in containers each with 20 ml of physiologic saline for a consecutive series of 30-min intervals and ADF concentration (absorption) was determined photometrically. The model was verified by three experiments. In experiment 1, the lower limit of quantification (LLoQ, coefficient of variation = 20 % and difference of 5 standard deviations (SD) from blank) of ADF in physiologic saline was determined by measuring the absorption of 15 dilutions of ADF in physiologic saline (containing 0.625 ng to 12.5 μg methylene blue/ml) photometrically for ten times. In experiment 2, long-term linearity of ADF perfusion/outflow was investigated using 11 specimens. The ADF released through the window was collected in the said containers separately for each consecutive interval of 30 min for up to 240 min. Absorption was determined and analysed by linear regression over time. In experiment 3, perfusion before (2×) and after single treatment according to the following three groups was measured: BisGMA-based sealant (Seal&Protect®), an acidic fluoride solution (elmex fluid®) and control (no treatment).

RESULTS

In experiment 1, the LLoQ was 0.005 μg methylene blue/ml. In experiment 2, permeability was different within the specimens and decreased highly linearly with time, allowing the prediction of future values. In experiment 3, Seal&Protect® completely occluded dentinal tubules. elmex fluid® increased tubular permeability by about 30 % compared to control.

CONCLUSIONS

A model comprising the use of artificial dentinal fluid was developed and validated allowing screening of therapeutic agents for the treatment of DH through reliable measurement of permeability of cervical root dentine.

CLINICAL RELEVANCE

The described in vitro model allows evaluation of potential agents for the treatment of DH at the clinically relevant cervical region of human teeth.

摘要

目的

本系列研究旨在开发并验证一种用于评估牙本质过敏症(DH)治疗方法的新模型。

材料与方法

用可流动复合树脂封闭拔除的人牙牙根。在牙颈部区域,通过封闭材料磨出一个3毫米宽的圆形窗口,深入牙本质1毫米。牙髓腔与含有蛋白质、无机盐和亚甲蓝的人工牙本质液(ADF)储存器相连。在牙髓压力升高时,通过上述窗口释放的ADF在连续30分钟的时间间隔内收集到每个装有20毫升生理盐水的容器中,并通过光度法测定ADF浓度(吸光度)。该模型通过三个实验进行验证。在实验1中,通过对生理盐水中15种ADF稀释液(含0.625纳克至12.5微克亚甲蓝/毫升)的吸光度进行十次光度测量,确定生理盐水中ADF的定量下限(LLoQ,变异系数=20%,与空白的差异为5个标准差(SD))。在实验2中,使用11个标本研究ADF灌注/流出的长期线性关系。通过上述窗口释放的ADF在连续30分钟的每个时间间隔分别收集到上述容器中,最长收集240分钟。通过对时间进行线性回归来确定并分析吸光度。在实验3中,测量以下三组单次治疗前后(各2次)的灌注情况:双甲基丙烯酸缩水甘油酯基封闭剂(Seal&Protect®)、酸性氟化物溶液(elmex fluid®)和对照组(未治疗)。

结果

在实验1中,LLoQ为0.005微克亚甲蓝/毫升。在实验2中,各标本的渗透性不同,且随时间高度线性下降,从而能够预测未来值。在实验3中,Seal&Protect®完全封闭了牙本质小管。与对照组相比,elmex fluid®使小管渗透性增加了约30%。

结论

开发并验证了一种使用人工牙本质液的模型,该模型能够通过可靠测量牙颈部牙本质的渗透性来筛选治疗DH的治疗剂。

临床意义

所描述的体外模型能够在人牙临床相关的颈部区域评估治疗DH的潜在药物。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/463a/4232750/690203dc14c2/784_2014_1194_Fig1_HTML.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验