Suppr超能文献

术中计算机断层扫描图像引导手术在初次与翻修脊柱手术中置入椎弓根螺钉和骨盆螺钉的准确性。

Accuracy of intraoperative computed tomography image-guided surgery in placing pedicle and pelvic screws for primary versus revision spine surgery.

作者信息

Hsieh Joseph C, Drazin Doniel, Firempong Alexander O, Pashman Robert, Johnson J Patrick, Kim Terrence T

机构信息

Departments of Neurosurgery and.

出版信息

Neurosurg Focus. 2014 Mar;36(3):E2. doi: 10.3171/2014.1.FOCUS13525.

Abstract

OBJECT

Revision spine surgery, which is challenging due to disrupted anatomy, poor fluoroscopic imaging, and altered tactile feedback, may benefit from CT image-guided surgery (CT-IGS). This study evaluates accuracy of CT-IGS-navigated screws in primary versus revision spine surgery.

METHODS

Pedicle and pelvic screws placed with the O-arm in 28 primary (313 screws) and 33 revision (429 screws) cases in which institutional postoperative CT scans were available were retrospectively reviewed for placement accuracy. Screw accuracy was categorized as 1) good (< 1-mm pedicle breach in any direction or "in-out-in" thoracic screws through the lateral thoracic pedicle wall and in the costovertebral joint); 2) fair (1- to 3-mm breach); or 3) poor (> 3-mm breach).

RESULTS

Use of CT-IGS resulted in high rates of good or fair screws for both primary (98.7%) and revision (98.6%) cases. Rates of good or fair screws were comparable for the following regions: C7-T3 at 100% (good or fair) in primary versus 100% (good or fair) in revision; T4-9 at 96.8% versus 100%; T10-L2 at 98.2% versus 99.3%; L3-5 at 100% versus 99.2%; and pelvis at 98.7% versus 98.6%, respectively. On the other hand, revision sacral screws had statistically significantly lower rates of good placement compared with primary (100% primary vs 80.6% revision, p = 0.027). Of these revision sacral screws, 11.1% had poor placement, with bicortical screws extending > 3 mm beyond the anterior cortex. Revision pelvic screws demonstrated the highest rate of fair placement (28%), with the mode of medial breach in all cases directed into the sacral-iliac joint.

CONCLUSIONS

In the cervical, thoracic, and lumbar spine, CT-IGS demonstrated comparable accuracy rates for both primary and revision spine surgery. Use of 3D imaging of the bony pedicle anatomy appears to be sufficient for the spine surgeon to overcome the difficulties associated with instrumentation in revision cases. Although the bony structures of sacral pedicles and pelvis are relatively larger, the complexity of local anatomy was not overcome with CT-IGS, and an increased trend toward inaccurate screw placement was demonstrated.

摘要

目的

翻修脊柱手术因解剖结构紊乱、透视成像不佳及触觉反馈改变而具有挑战性,可能从CT图像引导手术(CT-IGS)中获益。本研究评估CT-IGS引导下的螺钉在初次与翻修脊柱手术中的准确性。

方法

回顾性分析28例初次手术(313枚螺钉)和33例翻修手术(429枚螺钉)中使用O型臂置入椎弓根螺钉和骨盆螺钉的病例,这些病例均有术后机构CT扫描资料,以评估螺钉置入准确性。螺钉准确性分为:1)良好(任何方向椎弓根穿破<1mm,或“进出进”型胸椎螺钉穿过胸外侧椎弓根壁并进入肋椎关节);2)一般(穿破1至3mm);或3)差(穿破>3mm)。

结果

对于初次手术(98.7%)和翻修手术(98.6%)病例,使用CT-IGS均产生了较高比例的良好或一般螺钉。以下区域良好或一般螺钉的比例相当:C7-T3,初次手术为100%(良好或一般),翻修手术为100%(良好或一般);T4-9,分别为96.8%和100%;T10-L2,分别为98.2%和99.3%;L3-5,分别为100%和99.2%;骨盆,分别为98.7%和98.6%。另一方面,与初次手术相比,翻修骶骨螺钉良好置入率在统计学上显著较低(初次手术为100%,翻修手术为80.6%,p = 0.027)。在这些翻修骶骨螺钉中,11.1%置入不佳,双皮质螺钉向前皮质外延伸>3mm。翻修骨盆螺钉显示出一般置入率最高(28%),所有病例中内侧穿破的方式均指向骶髂关节。

结论

在颈椎、胸椎和腰椎,CT-IGS在初次和翻修脊柱手术中显示出相当的准确率。使用椎弓根骨结构的三维成像似乎足以让脊柱外科医生克服翻修病例中与器械操作相关的困难。尽管骶椎弓根和骨盆的骨结构相对较大,但CT-IGS并未克服局部解剖结构的复杂性,且显示出螺钉置入不准确的趋势增加。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验