Duenwald-Kuehl Sarah, Bates Melissa L, Cortes Sonia Y, Eldridge Marlowe W, Vanderby Ray
J Biomech Eng. 2014 Jul;136(7):0745041-5. doi: 10.1115/1.4027611.
A relationship between tendon stress and strain and ultrasonic echo intensity has previously been defined in tendons, demonstrating a correlation between tissue stiffness and echo intensity. An analogous relationship between volume-dependent pressure changes and echo intensity changes in inflating lungs would indicate a correlation between lung compliance and echo intensity. Lung compliance is an important metric to diagnose pathologies which affect lung tissue mechanics, such as emphysema and cystic fibrosis. The goal of this study is to demonstrate a correlation between ultrasound echo intensity and lung tissue mechanics in an ex vivo model using a fluid-filled negative pressure bath design which provides a controlled environment for ultrasonic and mechanical measurements. Lungs from 4 male Sprague-Dawley rats were removed and mechanically tested via inflation and deflation in a negative pressure chamber filled with hetastarch. Specific volumes (1, 2, 3, and 4 mL) were removed from the chamber using a syringe to create negative pressure, which resulted in lung inflation. A pressure transducer recorded the pressure around the lungs. From these data, lung compliance was calculated. Ultrasound images were captured through the chamber wall to determine echo intensity (grayscale brightness in the ultrasound image), which was then related to mechanical parameters. Ultrasound images of the lung were successfully captured through the chamber wall with sufficient resolution to deduce echo intensity changes in the lung tissue. Echo intensity (0-255 scale) increased with volumetric changes (18.4 ± 5.5, 22.6 ± 5.1, 26.1 ± 7.5, and 42.9 ± 19.5 for volumetric changes of 1, 2, 3, and 4 mL) in a pattern similar to pressure (-6.8 ± 1.7, -6.8 ± 1.4, -9.4 ± 0.7, and -16.9 ± 6.8 cm H2O for 1, 2, 3, and 4 mL), reflecting changes in lung compliance. Measured rat lung tissue compliance was comparable to reported values from ex vivo lungs (0.178 ± 0.067, 0.378 ± 0.051, 0.427 ± 0.062, and 0.350 ± 0.160 mL/cm H20 for 1, 2, 3, and 4 mL), supporting proof of concept for the experimental method. Changes in echo intensity reflected changes in lung compliance in this ex vivo model, thus, supporting our hypothesis that the stiffness-related changes in echo intensity originally seen in tendon can be similarly detected in lung tissue. The presented ultrasound-based methods allowed measurement of local lung tissue compliance in a controlled environment, however, the methods could be expanded to facilitate both ex vivo and in vivo studies.
先前已确定肌腱应力与应变和超声回波强度之间的关系,表明组织硬度与回波强度之间存在相关性。充气肺中与体积相关的压力变化和回波强度变化之间的类似关系将表明肺顺应性与回波强度之间存在相关性。肺顺应性是诊断影响肺组织力学的疾病(如肺气肿和囊性纤维化)的重要指标。本研究的目的是在离体模型中,使用充满液体的负压浴设计,为超声和力学测量提供可控环境,以证明超声回波强度与肺组织力学之间的相关性。从4只雄性Sprague-Dawley大鼠身上取出肺,在充满羟乙基淀粉的负压室中通过充气和放气进行力学测试。使用注射器从室中抽出特定体积(1、2、3和4 mL)以产生负压,从而导致肺充气。压力传感器记录肺周围的压力。根据这些数据计算肺顺应性。通过室壁捕获超声图像以确定回波强度(超声图像中的灰度亮度),然后将其与力学参数相关联。通过室壁成功捕获了具有足够分辨率的肺超声图像,以推断肺组织中的回波强度变化。回波强度(0 - 255级)随体积变化而增加(体积变化为1、2、3和4 mL时分别为18.4±5.5、22.6±5.1、26.1±7.5和42.9±19.5),其模式与压力相似(1、2、3和4 mL时分别为-6.8±1.7、-6.8±1.4、-9.4±0.7和-16.9±6.8 cm H2O),反映了肺顺应性的变化。测量的大鼠肺组织顺应性与离体肺的报告值相当(1、2、3和4 mL时分别为0.178±0.067、0.378±0.051、0.427±0.062和0.350±0.160 mL/cm H20),支持了该实验方法的概念验证。在这个离体模型中,回波强度的变化反映了肺顺应性的变化,因此,支持了我们的假设,即在肌腱中最初观察到的与硬度相关的回波强度变化在肺组织中也可以类似地检测到。所提出的基于超声的方法允许在可控环境中测量局部肺组织顺应性,然而,这些方法可以扩展以促进离体和体内研究。