Takada S
Aichi Gakuin Daigaku Shigakkai Shi. 1989 Dec;27(4):925-64.
The size sequence of the molar teeth in three genera, including seven species, of the Cercopithecidae was examined on the basis of mesiodistal and buccolingual crown diameters, and rectangle measurements (mesiodistal d. X buccolingual d.). The determination of molar size order was estimated by the three methods of mean values, size sequences and reductive indices (M2/M1, M3/M1). The results obtained are summarized as follows: 1. The molar size sequence of the seven species. The pattern of sequence in the molars of the Cercopithecidae was divided into six types: (I) M1 less than M2 less than M3 or (M1M2) less than M3, (II) M1 less than (M2M3), (III) M1 less than M3 less than M2, (IV) (M1M2M3), (V) (M3M1) less than M2, and (VI) M3 less than M1 less than M2 or M3 less than (M1M2). 2. The upper molars. i) The most frequent pattern of mean values found was type II for all the species of the Macaca and Colobus. The two species of Cercopithecus showed predominantly the characteristics of types III, IV and V. ii) The molar size sequence individual data revealed that in the mesiodistal crown diameter types I and II were distributed frequently in the Macaca, types IV and V in the Colobus, and type VI in the Cercopithecus. The reduction of the third molar, therefore, seemed to be more pronounced in the Cercopithecus when compared with the other two genus, Macaca and Colobus, because type VI is the type with more size reduction in the third molar. In the case of the buccolingual crown diameters, the most common size sequences were found in types II and III for the Macaca and Colobus. In the Cercopithecus, however, type V exceeded other types in frequence. iii) The results of the reductive indices showed that the second molars in the Colobus were greatly reduced compared to the first, followed by those of the Cercopithecus and Macaca. In the third molar reduction, the Cercopithecus had a relatively small third molar compared to the first, following the Colobus and Macaca. 3. The lower molars. i) The pattern in the mean values were frequently found to be type I for the Macaca and Colobus, and types III and II for the Cercopithecus. ii) The size sequence in the frequency of the mesiodistal crown diameter was well presented in type I for the Macaca and Colobus, while types IV and V were distributed frequently for Cercopithecus in which the reduction of the third molar was noticeable.(ABSTRACT TRUNCATED AT 400 WORDS)
基于近远中径和颊舌径以及矩形测量值(近远中径×颊舌径),对猕猴科三个属(包括七个物种)的磨牙大小序列进行了研究。通过平均值、大小序列和缩减指数(M2/M1、M3/M1)这三种方法来估计磨牙大小顺序。所得结果总结如下:1. 七个物种的磨牙大小序列。猕猴科磨牙的序列模式分为六种类型:(I)M1小于M2小于M3或(M1M2)小于M3,(II)M1小于(M2M3),(III)M1小于M3小于M2,(IV)(M1M2M3),(V)(M3M1)小于M2,以及(VI)M3小于M1小于M2或M3小于(M1M2)。2. 上颌磨牙。i)在猕猴属和疣猴属的所有物种中,最常见的平均值模式是类型II。猕猴属的两个物种主要表现出类型III、IV和V的特征。ii)磨牙大小序列的个体数据显示,在近远中径方面,类型I和II在猕猴属中分布频繁,类型IV和V在疣猴属中分布频繁,而类型VI在猕猴属中分布频繁。因此,与猕猴属和疣猴属这另外两个属相比,猕猴属第三磨牙的缩减似乎更为明显,因为类型VI是第三磨牙缩减程度更大的类型。在颊舌径方面,猕猴属和疣猴属中最常见的大小序列是类型II和III。然而,在猕猴属中,类型V的出现频率超过其他类型。iii)缩减指数的结果表明,与第一磨牙相比,疣猴属的第二磨牙大幅缩减,其次是猕猴属和猕猴属。在第三磨牙的缩减方面,与第一磨牙相比,猕猴属的第三磨牙相对较小,排在疣猴属和猕猴属之后。3. 下颌磨牙。i)在猕猴属和疣猴属中,平均值模式常见为类型I,而在猕猴属中常见为类型III和II。ii)近远中径频率方面的大小序列在猕猴属和疣猴属中以类型I表现良好,而在猕猴属中类型IV和V分布频繁,其中第三磨牙的缩减很明显。(摘要截取自400字)