Tsuruta Yusuke, Nakata Manabu, Nakamura Mitsuhiro, Matsuo Yukinori, Higashimura Kyoji, Monzen Hajime, Mizowaki Takashi, Hiraoka Masahiro
Division of Clinical Radiology Service, Kyoto University Hospital, Kyoto 606-8507, Japan.
Department of Radiation Oncology and Image-applied Therapy, Graduate School of Medicine, Kyoto University, Kyoto 606-8507, Japan.
Med Phys. 2014 Aug;41(8):081715. doi: 10.1118/1.4890592.
To compare the dosimetric performance of Acuros XB (AXB), anisotropic analytical algorithm (AAA), and x-ray voxel Monte Carlo (XVMC) in heterogeneous phantoms and lung stereotactic body radiotherapy (SBRT) plans.
Water- and lung-equivalent phantoms were combined to evaluate the percentage depth dose and dose profile. The radiation treatment machine Novalis (BrainLab AG, Feldkirchen, Germany) with an x-ray beam energy of 6 MV was used to calculate the doses in the composite phantom at a source-to-surface distance of 100 cm with a gantry angle of 0°. Subsequently, the clinical lung SBRT plans for the 26 consecutive patients were transferred from the iPlan (ver. 4.1; BrainLab AG) to the Eclipse treatment planning systems (ver. 11.0.3; Varian Medical Systems, Palo Alto, CA). The doses were then recalculated with AXB and AAA while maintaining the XVMC-calculated monitor units and beam arrangement. Then the dose-volumetric data obtained using the three different radiation dose calculation algorithms were compared.
The results from AXB and XVMC agreed with measurements within ± 3.0% for the lung-equivalent phantom with a 6 × 6 cm(2) field size, whereas AAA values were higher than measurements in the heterogeneous zone and near the boundary, with the greatest difference being 4.1%. AXB and XVMC agreed well with measurements in terms of the profile shape at the boundary of the heterogeneous zone. For the lung SBRT plans, AXB yielded lower values than XVMC in terms of the maximum doses of ITV and PTV; however, the differences were within ± 3.0%. In addition to the dose-volumetric data, the dose distribution analysis showed that AXB yielded dose distribution calculations that were closer to those with XVMC than did AAA. Means ± standard deviation of the computation time was 221.6 ± 53.1 s (range, 124-358 s), 66.1 ± 16.0 s (range, 42-94 s), and 6.7 ± 1.1 s (range, 5-9 s) for XVMC, AXB, and AAA, respectively.
In the phantom evaluations, AXB and XVMC agreed better with measurements than did AAA. Calculations differed in the density-changing zones (substance boundaries) between AXB/XVMC and AAA. In the lung SBRT cases, a comparative analysis of dose-volumetric data and dose distributions with XVMC demonstrated that the AXB provided better agreement with XVMC than AAA. The computation time of AXB was faster than that of XVMC; therefore, AXB has better balance in terms of the dosimetric performance and computation speed for clinical use than XVMC.
比较Acuros XB(AXB)、各向异性解析算法(AAA)和X射线体素蒙特卡罗(XVMC)在非均匀体模和肺部立体定向体部放射治疗(SBRT)计划中的剂量学性能。
将水等效体模和肺等效体模组合起来评估百分深度剂量和剂量分布。使用具有6MV X射线束能量的Novalis放射治疗机(德国费尔德基兴的BrainLab AG公司),在源皮距为100cm、机架角度为0°的条件下计算复合体模中的剂量。随后,将26例连续患者的临床肺部SBRT计划从iPlan(版本4.1;BrainLab AG公司)传输至Eclipse治疗计划系统(版本11.0.3;美国加利福尼亚州帕洛阿尔托的瓦里安医疗系统公司)。然后在保持XVMC计算的监测单位和射束排列的情况下,用AXB和AAA重新计算剂量。接着比较使用三种不同放射剂量计算算法获得的剂量体积数据。
对于6×6cm²射野大小的肺等效体模,AXB和XVMC的结果与测量值在±3.0%范围内相符,而AAA的值在非均匀区域和边界附近高于测量值,最大差异为4.1%。在非均匀区域边界处的剂量分布形状方面,AXB和XVMC与测量值吻合良好。对于肺部SBRT计划,在内部靶区(ITV)和计划靶区(PTV)的最大剂量方面,AXB的值低于XVMC;然而,差异在±3.0%以内。除剂量体积数据外,剂量分布分析表明,AXB产生的剂量分布计算结果比AAA更接近XVMC的结果。XVMC、AXB和AAA的计算时间平均值±标准差分别为221.6±53.1秒(范围124 - 358秒)、66.1±16.0秒(范围42 - 94秒)和6.7±1.1秒(范围5 - 9秒)。
在体模评估中,AXB和XVMC与测量值的吻合度优于AAA。AXB/XVMC与AAA在密度变化区域(物质边界)的计算存在差异。在肺部SBRT病例中,与XVMC对剂量体积数据和剂量分布的比较分析表明,AXB与XVMC的一致性优于AAA。AXB的计算时间比XVMC快;因此,在临床应用中,AXB在剂量学性能和计算速度方面比XVMC具有更好的平衡。