Majidi Shahram, Watanabe Masaki, Chaudhry Saqib A, Qureshi Adnan I
Zeenat Qureshi Stroke Research Center, University of Minnesota, Minneapolis, MN.
J Vasc Interv Neurol. 2014 Sep;7(3):41-5.
There have been growing concerns regarding delayed aneurysm rupture subsequent to the flow-diverting stent deployment. Therefore, more investigations are needed regarding hemodynamic changes secondary to flow-diverting stent deployment.
To study intra-aneurysmal and perianeurysmal pressures after partial and complete flow impairment into the aneurysm.
A silicone model of an 8-mm-sized aneurysm (neck diameter: 5 mm, vessel size: 4 mm) was used. The aneurysm wall was encapsulated and sealed within a 5 ml syringe filled with saline and a pressure sensor guide wire (ComboWire, Volcano Corp.) to detect pressure changes in the perivascular compartment (outer aneurysm wall). A second pressure sensor guide wire was advanced inside the aneurysm sac. Both pressure sensors were continuously measuring pressure inside and outside the aneurysm under pulsatile flow under the following conditions: 1) baseline (reference); 2) a 16 mm by 3.75 mm flow-diverting stent (ev3/Covidien Vascular, Mansfield, MA) deployed in front of the aneurysm; 3) two flow-diverting stents (16 mm by 3.5 mm) were deployed; and 4) a covered stent (4 mm by 16 mm VeriFlex coronary artery stent covered with rubber sheet) was deployed.
Mean (±SD) baseline pressures inside and outside the aneurysm were 53.9 (±2.4) mmHg (range 120-40 mmHg) and 15.4 (±0.7) mmHg (range 40-8mmHg), respectively. There was no change in pressure inside and outside the aneurysm after deploying the first and second flow-diverting stents (partial flow impairment) and it remained at 53.9 (±2.7) mmHg and 14.9 (±1) mmHg for the pressure inside and outside the aneurysm, respectively. The pressure recording from outside the aneurysm dropped from 15.4 (±0.7) mmHg to 0.3 (±0.7) mmHg after deploying the covered stent (complete flow impairment). There was no change in pressure inside the aneurysm after deploying the covered stent. Mean (±SD) pressure within the aneurysm was 55.1 (±1.7) mmHg and it remained 54.7 (±1.7) mmHg after covered stent deployment.
Our findings suggest a major discordance between the pressures within the aneurysm and partial or complete flow impairment (flow independent). The outer wall pressure is reduced after covered stent placement. These finding may assist clinicians in better understanding of aneurysm hemodynamics and rupture after flow-diverting stent deployment.
对于血流导向支架置入术后动脉瘤延迟破裂的担忧日益增加。因此,需要对血流导向支架置入术后继发的血流动力学变化进行更多研究。
研究动脉瘤内部分血流和完全血流受阻后动脉瘤内及瘤周压力。
使用一个8毫米大小动脉瘤的硅胶模型(颈部直径:5毫米,血管大小:4毫米)。将动脉瘤壁封装并密封在一个装有生理盐水的5毫升注射器中,并使用压力传感器导丝(ComboWire,Volcano公司)检测血管周围腔室(动脉瘤外壁)的压力变化。将第二根压力传感器导丝推进动脉瘤腔内。在以下条件下的脉动血流中,两个压力传感器持续测量动脉瘤内外的压力:1)基线(对照);2)在动脉瘤前方置入一个16毫米×3.75毫米的血流导向支架(ev3/Covidien血管公司,马萨诸塞州曼斯菲尔德);3)置入两个血流导向支架(16毫米×3.5毫米);4)置入一个覆膜支架(4毫米×16毫米的VeriFlex冠状动脉支架,覆盖橡胶片)。
动脉瘤内外的平均(±标准差)基线压力分别为53.9(±2.4)毫米汞柱(范围120 - 40毫米汞柱)和15.4(±0.7)毫米汞柱(范围40 - 8毫米汞柱)。置入第一和第二个血流导向支架(部分血流受阻)后,动脉瘤内外压力无变化,动脉瘤内压力保持在53.9(±2.7)毫米汞柱,动脉瘤外压力保持在14.9(±1)毫米汞柱。置入覆膜支架(完全血流受阻)后,动脉瘤外的压力记录从15.4(±0.7)毫米汞柱降至0.3(±0.7)毫米汞柱。置入覆膜支架后动脉瘤内压力无变化。动脉瘤内的平均(±标准差)压力为55.1(±1.7)毫米汞柱,置入覆膜支架后仍为54.7(±1.7)毫米汞柱。
我们的研究结果表明动脉瘤内压力与部分或完全血流受阻(血流无关)之间存在重大差异。置入覆膜支架后外壁压力降低。这些发现可能有助于临床医生更好地理解血流导向支架置入术后的动脉瘤血流动力学和破裂情况。