Majdi Joseph A, Minnikanti Saugandhika, Peixoto Nathalia, Agrawal Anant, Cohen Ethan D
Division of Biomedical Physics, Office of Science and Engineering Labs, Center for Devices and Radiological Health, Food and Drug Administration, Rm 1204 Bldg 62. White Oak Federal Research Labs, Silver Spring, MD 20993-0002, USA.
J Neural Eng. 2015 Feb;12(1):016006. doi: 10.1088/1741-2560/12/1/016006. Epub 2014 Dec 4.
Epiretinal prostheses seek to effectively stimulate the retina by positioning electrode arrays close to its surface so current pulses generate narrow retinal electric fields. Our objective was to evaluate the use of the electrical impedance of insulated platinum electrodes as a measure of the proximity of insulated platinum electrodes to the inner surface of the retina.
We examined the impedance of platinum disk electrodes, 0.25 mm in diameter, insulated with two widths (0.8 and 1.6 mm outer diameter) of transparent fluoropolymer in a rabbit retinal eyecup preparation. Optical coherence tomography measured the electrode's proximity to the retinal surface which was correlated with changes in the voltage waveform at the electrode. Electrode impedance changes during retinal deformation were also studied.
When the 1.6 mm diameter insulated electrodes advanced towards the retinal surface from 1000 μm, their voltage step at current pulse onset increased, reflecting an access resistance increase of 3880 ± 630 Ω, with the 50% midpoint averaging 30 μm, while thin 0.8 mm insulated electrode advancement showed an access resistance increase 50% midpoint averaging 16 μm. Using impedance spectroscopy, electrode-retina proximity differences were seen in the 1.6 mm insulated electrode impedance modulus between 1 and 100 kHz and the waveform phase angle at 0.3-10 kHz, while thin 0.8 mm insulated electrode advancement produced smaller impedance modulus changes with retinal proximity between 3 and 100 kHz. These impedance changes with retinal proximity may reflect different sized zones of eye wall being coupled in series with the insulated platinum electrode.
The proximity of stimulus electrodes to neural tissue in fluid-filled spaces can be estimated from access resistance changes in the stimulus pulse waveform. Because many prosthetic devices allow back telemetry communication of the stimulus electrode waveform, it is possible these series resistance increases observed with retinal proximity could be used as a metric of stimulus electrode placement.
视网膜外假体试图通过将电极阵列放置在视网膜表面附近来有效刺激视网膜,以便电流脉冲产生狭窄的视网膜电场。我们的目的是评估绝缘铂电极的电阻抗,以此作为衡量绝缘铂电极与视网膜内表面接近程度的指标。
我们在兔视网膜眼杯标本中,检测了直径为0.25毫米、用两种宽度(外径0.8毫米和1.6毫米)的透明含氟聚合物绝缘的铂盘电极的电阻抗。光学相干断层扫描测量电极与视网膜表面的接近程度,并将其与电极处电压波形的变化相关联。还研究了视网膜变形过程中电极电阻抗的变化。
当直径1.6毫米的绝缘电极从1000微米向视网膜表面推进时,其在电流脉冲开始时的电压阶跃增加,反映出接入电阻增加了3880±630Ω,50%中点平均为30微米,而外径0.8毫米的薄绝缘电极推进时,接入电阻增加50%中点平均为16微米。使用阻抗谱,在1至100千赫之间,1.6毫米绝缘电极的阻抗模量以及在0.3至10千赫时的波形相角显示出电极与视网膜接近程度的差异,而外径0.8毫米的薄绝缘电极推进时,在3至100千赫之间,随着与视网膜接近程度的变化,阻抗模量变化较小。这些随视网膜接近程度的阻抗变化可能反映了与绝缘铂电极串联耦合的不同大小的眼壁区域。
刺激电极与充满液体空间中的神经组织的接近程度可通过刺激脉冲波形中的接入电阻变化来估计。由于许多假体装置允许刺激电极波形进行反向遥测通信,因此随着与视网膜接近程度增加而观察到的这些串联电阻增加有可能用作刺激电极放置的指标。