Epstein N R, Meaney P M, Paulsen K D
Schulich School of Engineering, University of Calgary, 2500 University Dr. NW, Calgary, Alberta T2N 1N4, Canada.
Thayer School of Engineering, Dartmouth College, 14 Engineering Dr., Hanover, New Hampshire 03755, USA.
Rev Sci Instrum. 2014 Dec;85(12):124704. doi: 10.1063/1.4901936.
A biomedical microwave tomography system with 3D-imaging capabilities has been constructed and translated to the clinic. Updates to the hardware and reconfiguration of the electronic-network layouts in a more compartmentalized construct have streamlined system packaging. Upgrades to the data acquisition and microwave components have increased data-acquisition speeds and improved system performance. By incorporating analog-to-digital boards that accommodate the linear amplification and dynamic-range coverage our system requires, a complete set of data (for a fixed array position at a single frequency) is now acquired in 5.8 s. Replacement of key components (e.g., switches and power dividers) by devices with improved operational bandwidths has enhanced system response over a wider frequency range. High-integrity, low-power signals are routinely measured down to -130 dBm for frequencies ranging from 500 to 2300 MHz. Adequate inter-channel isolation has been maintained, and a dynamic range >110 dB has been achieved for the full operating frequency range (500-2900 MHz). For our primary band of interest, the associated measurement deviations are less than 0.33% and 0.5° for signal amplitude and phase values, respectively. A modified monopole antenna array (composed of two interwoven eight-element sub-arrays), in conjunction with an updated motion-control system capable of independently moving the sub-arrays to various in-plane and cross-plane positions within the illumination chamber, has been configured in the new design for full volumetric data acquisition. Signal-to-noise ratios (SNRs) are more than adequate for all transmit/receive antenna pairs over the full frequency range and for the variety of in-plane and cross-plane configurations. For proximal receivers, in-plane SNRs greater than 80 dB are observed up to 2900 MHz, while cross-plane SNRs greater than 80 dB are seen for 6 cm sub-array spacing (for frequencies up to 1500 MHz). We demonstrate accurate recovery of 3D dielectric property distributions for breast-like phantoms with tumor inclusions utilizing both the in-plane and new cross-plane data.
一个具有三维成像能力的生物医学微波断层扫描系统已构建完成并投入临床应用。硬件的更新以及电子网络布局在更具分区化结构中的重新配置,简化了系统封装。数据采集和微波组件的升级提高了数据采集速度并改善了系统性能。通过纳入能满足我们系统所需线性放大和动态范围覆盖的模数转换板,现在在5.8秒内就能采集到完整的数据集(针对单个频率下的固定阵列位置)。用具有更高工作带宽的器件替换关键组件(如开关和功率分配器),增强了系统在更宽频率范围内的响应。对于500至2300兆赫兹的频率,常规测量的高完整性、低功率信号可达-130分贝毫瓦。保持了足够的通道间隔离,并且在整个工作频率范围(500 - 2900兆赫兹)内实现了大于110分贝的动态范围。对于我们主要关注的频段,信号幅度和相位值的相关测量偏差分别小于0.33%和0.5°。在新设计中配置了一个改进的单极天线阵列(由两个交织的八元子阵列组成),并结合了一个更新的运动控制系统,该系统能够将子阵列独立移动到照明室内的各种平面内和平面外位置,以进行全容积数据采集。在整个频率范围内以及各种平面内和平面外配置下,所有发射/接收天线对的信噪比都足够高。对于近端接收器,在高达2900兆赫兹的频率下,平面内信噪比大于80分贝,而对于6厘米的子阵列间距(频率高达1500兆赫兹),平面外信噪比大于80分贝。我们利用平面内和新的平面外数据,展示了对于含有肿瘤内含物的乳房状体模的三维介电特性分布的精确恢复。