Kauppila Tiina J, Kersten Hendrik, Benter Thorsten
Division of Pharmaceutical Chemistry and Technology, Faculty of Pharmacy, University of Helsinki, 00014, Helsinki, Finland,
J Am Soc Mass Spectrom. 2015 Jun;26(6):1036-45. doi: 10.1007/s13361-015-1092-3. Epub 2015 Apr 1.
Seventy-seven EPA priority environmental pollutants were analyzed using gas chromatography-mass spectrometry (GC-MS) equipped with an optimized atmospheric pressure photoionization (APPI) and an atmospheric pressure laser ionization (APLI) interface with and without dopants. The analyzed compounds included e.g., polycyclic aromatic hydrocarbons (PAHs), nitro compounds, halogenated compounds, aromatic compounds with phenolic, acidic, alcohol, and amino groups, phthalate and adipatic esters, and aliphatic ethers. Toluene, anisole, chlorobenzene, and acetone were tested as dopants. The widest range of analytes was ionized using direct APPI (66/77 compounds). The introduction of dopants decreased the amount of compounds ionized in APPI (e.g., 54/77 with toluene), but in many cases the ionization efficiency increased. While in direct APPI the formation of molecular ions via photoionization was the main ionization reaction, dopant-assisted (DA) APPI promoted ionization reactions, such as charge exchange and proton transfer. Direct APLI ionized a much smaller amount of compounds than APPI (41/77 compounds), showing selectivity towards compounds with low ionization energies (IEs) and long-lived resonantly excited intermediate states. DA-APLI, however, was able to ionize a higher amount of compounds (e.g. 51/77 with toluene), as the ionization took place entirely through dopant-assisted ion/molecule reactions similar to those in DA-APPI. Best ionization efficiency in APPI and APLI (both direct and DA) was obtained for PAHs and aromatics with O- and N-functionalities, whereas nitro compounds and aliphatic ethers were the most difficult to ionize. Halogenated aromatics and esters were (mainly) ionized in APPI, but not in APLI.
使用配备优化的大气压光电离(APPI)和大气压激光电离(APLI)接口(有无掺杂剂)的气相色谱-质谱联用仪(GC-MS)分析了77种美国环境保护局(EPA)优先环境污染物。分析的化合物包括多环芳烃(PAHs)、硝基化合物、卤代化合物、带有酚基、酸性、醇基和氨基的芳香化合物、邻苯二甲酸酯和己二酸酯以及脂肪族醚等。甲苯、苯甲醚、氯苯和丙酮被用作掺杂剂进行测试。使用直接APPI时,电离的分析物范围最广(66/77种化合物)。掺杂剂的引入减少了APPI中电离的化合物数量(例如,使用甲苯时为54/77种),但在许多情况下电离效率有所提高。在直接APPI中,通过光电离形成分子离子是主要的电离反应,而掺杂剂辅助(DA)APPI促进了电荷交换和质子转移等电离反应。直接APLI电离的化合物数量比APPI少得多(41/77种化合物),对具有低电离能(IEs)和长寿命共振激发中间态的化合物具有选择性。然而,DA-APLI能够电离更多的化合物(例如,使用甲苯时为51/77种),因为电离完全通过与DA-APPI中类似的掺杂剂辅助离子/分子反应进行。对于具有O和N官能团的PAHs和芳烃,在APPI和APLI(直接和DA)中均获得了最佳电离效率,而硝基化合物和脂肪族醚最难电离。卤代芳烃和酯(主要)在APPI中电离,但不在APLI中电离。