Touati Mostefa, Knipfer Thorsten, Visnovitz Tamás, Kameli Abdelkrim, Fricke Wieland
Department of Biology, Faculty of Nature and Life Sciences, University Ziane Achour, Djelfa, Algeria.
University College Dublin, School of Biology and Environmental Science, Science Centre West, Belfield, Dublin 4, Ireland Present address: Department of Viticulture and Enology, University of California, Davis, CA 95616-5270, USA.
Plant Cell Physiol. 2015 Jul;56(7):1364-73. doi: 10.1093/pcp/pcv055. Epub 2015 Apr 22.
The aim of the present study was to assess the mechanical and hydraulic limitation of growth in leaf epidermal cells of barley (Hordeum vulgare L.) in response to agents which affect cellular water (mercuric chloride, HgCl(2)) and potassium (cesium chloride, CsCl; tetraethylammonium, TEA) transport, pump activity of plasma membrane H(+)-ATPase and wall acidification (fusicoccin, FC). Cell turgor (P) was measured with the cell pressure probe, and cell osmotic pressure (π) was analyzed through picoliter osmometry of single-cell extracts. A wall extensibility coefficient (M) and tissue hydraulic conductance coefficient (L) were derived using the Lockhart equation. There was a significant positive linear relationship between relative elemental growth rate and P, which fit all treatments, with an overall apparent yield threshold of 0.368 MPa. Differences in growth between treatments could be explained through differences in P. A comparison of L and M showed that growth in all except the FC treatment was co-limited through hydraulic and mechanical properties, though to various extents. This was accompanied by significant (0.17-0.24 MPa) differences in water potential (ΔΨ) between xylem and epidermal cells in the leaf elongation zone. In contrast, FC-treated leaves showed ΔΨ close to zero and a 10-fold increase in L.
本研究的目的是评估大麦(Hordeum vulgare L.)叶片表皮细胞生长的机械和水力限制,以响应影响细胞水分(氯化汞,HgCl₂)和钾(氯化铯,CsCl;四乙铵,TEA)运输、质膜H⁺-ATP酶泵活性和细胞壁酸化(壳梭孢菌素,FC)的试剂。用细胞压力探针测量细胞膨压(P),并通过单细胞提取物的皮升渗透压测定法分析细胞渗透压(π)。使用洛克哈特方程得出细胞壁延伸系数(M)和组织水力传导系数(L)。相对元素生长速率与P之间存在显著的正线性关系,适用于所有处理,总体表观产量阈值为0.368 MPa。处理之间生长的差异可以通过P的差异来解释。L和M的比较表明,除FC处理外,所有处理的生长都受到水力和机械特性的共同限制,尽管程度不同。这伴随着叶片伸长区木质部和表皮细胞之间水势(ΔΨ)的显著差异(0.17 - 0.24 MPa)。相比之下,FC处理的叶片显示ΔΨ接近零,L增加了10倍。