Department of Chemical and Biomolecular Engineering, New York University Polytechnic School of Engineering, Six MetroTech Center, Brooklyn, NY 11201, United States.
Department of Chemical and Biomolecular Engineering, New York University Polytechnic School of Engineering, Six MetroTech Center, Brooklyn, NY 11201, United States.
Biosens Bioelectron. 2015 Oct 15;72:100-6. doi: 10.1016/j.bios.2015.04.084. Epub 2015 Apr 28.
An ultrasensitive immunosensor based on potentiometric ELISA for the detection of a cardiac biomarker, troponin I-T-C (Tn I-T-C) complex, was developed. The sensor fabrication involves typical sandwich ELISA procedures, while the final signal readout was achieved using open circuit potentiometry (OCP). Glassy carbon (GC) working electrodes were first coated with emulsion-polymerized polyaniline/dinonylnaphthalenesulfonic acid (PANI/DNNSA) and the coated surface was utilized as a transducer layer on which sandwich ELISA incubation steps were performed. An enzymatic reaction between o-phenylenediamine (OPD) and hydrogen peroxide (H2O2) was catalyzed by horseradish peroxidase (HRP) labeled on the secondary antibodies. The polymer transducer charged state was mediated through electron (e(-)) and charge transfers between the transducer and charged species generated by the same enzymatic reaction. Such a change in the polymer transducer led to potential variations against an Ag/AgCl reference electrode as a function of Tn I-T-C complex concentration during incubations. The sequence of OPD and H2O2 additions, electrochemical properties of the PANI/DNNSA layer and non-specific binding prevention were all crucial factors for the assay performance. Under optimized conditions, the assay has a low limit of detection (LOD) (< 5 pg/mL or 56 fM), a wide dynamic range (> 6 orders of magnitude), high repeatability (coefficient of variance < 8% for all concentrations higher than 5 pg/mL) and a short detection time (< 10 min).
基于电势酶联免疫吸附测定(ELISA)的超灵敏免疫传感器,用于检测心脏生物标志物肌钙蛋白 I-T-C(Tn I-T-C)复合物,已被开发出来。传感器的制造涉及典型的三明治 ELISA 程序,而最终的信号读出则是通过开路电位法(OCP)实现的。玻碳(GC)工作电极首先涂有乳液聚合的聚苯胺/二壬基萘磺酸(PANI/DNNSA),并将涂覆的表面用作传感器层,在其上进行三明治 ELISA 孵育步骤。辣根过氧化物酶(HRP)标记的二级抗体在 o-苯二胺(OPD)和过氧化氢(H2O2)之间进行酶促反应。聚合物传感器的带电状态通过传感器和由相同酶促反应产生的带电物质之间的电子(e(-))和电荷转移来介导。聚合物传感器的这种变化导致在孵育过程中 Tn I-T-C 复合物浓度变化时,相对于 Ag/AgCl 参比电极的电位变化。OPD 和 H2O2 添加的顺序、PANI/DNNSA 层的电化学性质和非特异性结合的预防都是测定性能的关键因素。在优化条件下,该测定法具有较低的检测限(LOD)(<5pg/mL 或 56fM)、较宽的动态范围(>6 个数量级)、高重复性(所有浓度高于 5pg/mL 时,变异系数<8%)和较短的检测时间(<10min)。