Ahn Sang Hee, Gil Moon Soo, Lee Doo Sung, Han Youngyih, Park Hee Chul, Sohn Jason W, Kim Hye Yeong, Shin Eun Hyuk, Yu Jeong Il, Noh Jae Myoung, Cho Jun Sang, Ahn Sung Hwan, Choi Doo Ho
Department of Health Sciences and Technology, Samsung Advanced Institute for Health Sciences and Technology, Sungkyunkwan University, Seoul 135-710, Korea.
Sungkyunkwan University School of Chemical Engineering, Suwon 440-746, Korea.
Med Phys. 2015 May;42(5):2626-37. doi: 10.1118/1.4916663.
The aim of this study is to investigate the use of mixture of BaSO4 and biodegradable polymer as an injectable nonmetallic fiducial marker to reduce artifacts in x-ray images, decrease the absorbed dose distortion in proton therapy, and replace permanent metal markers.
Two samples were made with 90 wt. % polymer phosphate buffer saline (PBS) and 10 wt. % BaSO4 (B1) or 20 wt. % BaSO4 (B2). Two animal models (mice and rats) were used. To test the injectability and in vivo gelation, a volume of 200 μl at a pH 5.8 were injected into the Sprague-Dawley rats. After sacrificing the rats over time, the authors checked the gel morphology. Detectability of the markers in the x-ray images was tested for two sizes (diameters of 1 and 2 mm) for B1 and B2. Four samples were injected into BALB/C mice. The polymer mixed with BaSO4 transform from SOL at 20 °C with a pH of 6.0 to GEL in the living body at 37 °C with a pH of 7.4, so the size of the fiducial marker could be controlled by adjusting the injected volume. The detectability of the BaSO4 marker was measured in x-ray images of cone beam CT (CBCT), on-board imager [anterior-posterior (AP), lateral], and fluoroscopy (AP, lateral) using a Novalis-TX (Varian Medical Systems, Palo Alto, CA) repeatedly over 4 months. The volume, HU, and artifacts for the markers were measured in the CBCT images. Artifacts were compared to those of gold marker by analyzing the HU distribution. The dose distortion in proton therapy was computed by using a Monte Carlo (MC) code. A cylindrical shaped marker (diameter: 1 or 2 mm, length: 3 mm) made of gold, stainless-steel [304], titanium, and 20 wt. % BaSO4 was positioned at the center of the spread-out Bragg peak (SOBP) in parallel or perpendicular to the beam entrance. The dose distortion was measured on the depth dose profile across the markers.
Transformation to GEL and the biodegradation were verified. All BaSO4 markers could be detected in the CBCT. In the OBI and fluoroscopy images, all markers visible in the AP, but only B2(2 mm) could be identified in the lateral images. Changes of BaSO4 position were not detected in vivo (mice). The volume of the markers decreased by up to 65% and the HU increased by 22%, on average. The mean HU values around the B1, B2, and gold markers were 121.30 [standard deviation (SD): 54.86], 126.31 (SD: 62.13), and 1070.7 (SD: 235.16), respectively. The MC-simulated dose distortion for the BaSO4 markers was less than that of the commercially used markers. The dose reduction due to the gold marker was largest (15.05%) followed by stainless steel (7.92%) and titanium (6.92%). Dose reduction by B2 (2 mm) was 4.75% and 0.53% in parallel and perpendicular orientations, respectively.
BaSO4 mixed with PBS is a good contrast agent in biodegradable polymer marker because of minimal artifacts in x-ray images and minimal dose reduction in proton therapy. The flexibility of the size is considered to be an advantage of this material over solid type fiducials.
本研究旨在探讨硫酸钡(BaSO4)与可生物降解聚合物的混合物作为可注射非金属基准标记物的应用,以减少X射线图像中的伪影,降低质子治疗中吸收剂量的畸变,并替代永久性金属标记物。
制备了两个样品,一个含90 wt.%聚合物磷酸盐缓冲盐水(PBS)和10 wt.% BaSO4(B1),另一个含90 wt.%聚合物磷酸盐缓冲盐水(PBS)和20 wt.% BaSO4(B2)。使用了两种动物模型(小鼠和大鼠)。为测试其可注射性和体内凝胶化,将200 μl pH值为5.8的样品注入Sprague-Dawley大鼠体内。随着时间推移处死大鼠后,作者检查了凝胶形态。针对B1和B2的两种尺寸(直径1和2 mm)测试了标记物在X射线图像中的可检测性。将四个样品注入BALB/C小鼠体内。与BaSO4混合的聚合物在20°C、pH值为6.0时为溶胶状态,在37°C、pH值为7.4的活体中转变为凝胶状态,因此可通过调整注射体积来控制基准标记物的尺寸。使用瓦里安医疗系统公司(加利福尼亚州帕洛阿尔托)的Novalis-TX,在4个月内反复在锥束CT(CBCT)、机载成像仪[前后位(AP)、侧位]和荧光透视(AP、侧位)的X射线图像中测量BaSO4标记物的可检测性。在CBCT图像中测量标记物的体积、HU值和伪影。通过分析HU分布,将伪影与金标记物的伪影进行比较。使用蒙特卡罗(MC)代码计算质子治疗中的剂量畸变。将由金、不锈钢[304]、钛和20 wt.% BaSO4制成的圆柱形标记物(直径:1或2 mm,长度:3 mm)平行或垂直于束流入口置于扩展布拉格峰(SOBP)中心。在穿过标记物的深度剂量曲线上测量剂量畸变。
证实了向凝胶状态的转变和生物降解。所有BaSO4标记物在CBCT中均可检测到。在机载成像(OBI)和荧光透视图像中,AP方向上所有标记物均可见,但侧位图像中仅B2(2 mm)可识别。在体内(小鼠)未检测到BaSO4位置的变化。标记物的体积平均减少了65%,HU值平均增加了22%。B1、B2和金标记物周围的平均HU值分别为121.30 [标准差(SD):54.86]、126.31(SD:62.13)和1070.7(SD:235.16)。BaSO4标记物的MC模拟剂量畸变小于商业使用的标记物。金标记物导致的剂量减少最大(15.05%),其次是不锈钢(7.92%)和钛(6.92%)。B2(2 mm)在平行和垂直方向上的剂量减少分别为4.75%和0.53%。
由于在X射线图像中伪影最小且在质子治疗中剂量减少最小,BaSO4与PBS混合是可生物降解聚合物标记物中一种良好的对比剂。尺寸的灵活性被认为是这种材料相对于固体型基准标记物的一个优势。