Janyasuthiwong Suthee, Phiri Sheila M, Kijjanapanich Pimluck, Rene Eldon R, Esposito Giovanni, Lens Piet N L
a Department of Environmental Engineering and Water Technology , UNESCO-IHE Institute for Water Education , Westvest 7, 2611 AX Delft , The Netherlands.
b Department of Environmental Engineering, Faculty of Engineering , Chiang Mai University , Chiang Mai 50200 , Thailand.
Environ Technol. 2015;36(24):3071-83. doi: 10.1080/09593330.2015.1053537. Epub 2015 Jun 17.
The use of agricultural wastes (groundnut shell, orange and banana peel, rice husk, coconut husk and Wawa tree saw dust) as potential cost-effective adsorbent for heavy metal removal from wastewater was evaluated. The effect of pH (2.0-6.0), adsorbent dosage (0.6-2.2 g), contact time (10-130 min) and initial concentration (Pb: 5-105 mg/L, Cu and Zn: 2.5-52.7 mg/L) on the metal removal efficiency and uptake capacity were investigated using response surface methodology to optimize the process conditions. Groundnut shell showed a high potential to remove Cu, Pb and Zn from synthetic wastewater. The highest removal efficiencies with groundnut as the adsorbent were 85% at pH 5.0 for Cu and 98% at pH 3.0 for Pb and Zn. The optimum conditions obtained were 2.5 g adsorbent with 40.7 mg/L Cu at pH 4.4 and 64 min contact time, 2.5 g adsorbent with 196.1 mg/L Pb at pH 5.6 and 60 min contact time and 3.1 g adsorbent with 70.2 mg/L Zn at pH 4.3 and 50 min contact time, for Cu, Pb and Zn, respectively. The regeneration of the groundnut shell was possible for a maximum of three cycles using 0.2 M HCl as the desorbing solution without any significant change in the adsorbing efficiency.
评估了使用农业废弃物(花生壳、橙子皮和香蕉皮、稻壳、椰壳和瓦瓦树锯末)作为从废水中去除重金属的潜在经济高效吸附剂的情况。采用响应面法研究了pH值(2.0 - 6.0)、吸附剂用量(0.6 - 2.2 g)、接触时间(10 - 130分钟)和初始浓度(铅:5 - 105 mg/L,铜和锌:2.5 - 52.7 mg/L)对金属去除效率和吸附容量的影响,以优化工艺条件。花生壳显示出从合成废水中去除铜、铅和锌的巨大潜力。以花生壳为吸附剂时,对铜在pH 5.0时的最高去除效率为85%,对铅和锌在pH 3.0时的最高去除效率为98%。获得的最佳条件分别为:对于铜,在pH 4.4、接触时间64分钟时使用2.5 g吸附剂处理40.7 mg/L的铜;对于铅,在pH 5.6、接触时间60分钟时使用2.5 g吸附剂处理196.1 mg/L的铅;对于锌,在pH 4.3、接触时间50分钟时使用3.1 g吸附剂处理70.2 mg/L的锌。使用0.2 M盐酸作为解吸溶液,花生壳最多可再生三个循环,且吸附效率无显著变化。