Johari Masume, Kaviani Farzaneh, Saeedi Arman
Tabriz University of Medical Sciences, Tabriz, Iran.
Open Dent J. 2015 Jul 31;9:287-91. doi: 10.2174/1874210601509010287. eCollection 2015.
Orthodontic mini-implants have been incorporated into orthodontic treatment modalities. Adequate bone at mini-implant placement site can influence the success or failure of anchorage. The present study was to determine the thickness of cortical bone in the maxillary mid-palatal area at predetermined points for the placement of orthodontic mini-implants using Cone Beam CT technique in order to evaluate the relationship of these values with the facial height. Materials and Methods : A total of 161 patients, consisting of 63 males (39.13%) and 98 females (60.87%), were evaluated in the present study; 38% of the subjects had normal facial height, 29% had short face and 33% had long face. In order to determine which patient belongs to which facial height category, i.e. normal, long or short, two angular and linear evaluations were used: the angle between S-N and Go-Me lines and the S-Go/N-Me ratio. Twenty points were evaluated in all the samples. First the incisive foramen was located. The paracoronal cross-sections were prepared at distances of 4, 8, 16 and 24 mm from the distal wall of the incisive foramen and on each cross-section the mid-sagittal and para-sagittal areas were determined bilaterally at 3- and 6-mm distances (a total of 5 points). The thicknesses of the cortical plate of bone were determined at the predetermined points. Results : There was a significant relationship between the mean cortical bone thickness and facial height (p<0.01), with significantly less thickness in long faces compared to short faces. However, the thickness of cortical bone in normal faces was similar to that in long and short faces. Separate evaluation of the points showed that at point a16 subjects with short faces had thicker cortical bone compared to subjects with long and normal faces. At point b8 in long faces, the thickness of the cortical bone was significantly less than that in short and normal faces. At point d8, the thickness of the cortical bone in subjects with short faces was significantly higher than that in subjects with long faces. Conclusion : At the point a16 the cortical bone thickness in short faces was significantly higher than normal and long faces. The lower thickness of the cortical bone in the palatal area at points b8 and d8 in subjects with long faces might indicate a lower anchorage value of these points in these subjects.
正畸微型种植体已被纳入正畸治疗方式。微型种植体植入部位有足够的骨量会影响支抗的成败。本研究旨在使用锥形束CT技术确定上颌中腭部预定正畸微型种植体植入点处皮质骨的厚度,以评估这些值与面高的关系。材料与方法:本研究共评估了161例患者,其中男性63例(39.13%),女性98例(60.87%);38%的受试者面高正常,29%为短面型,33%为长面型。为了确定患者属于哪种面高类型,即正常、长面或短面,采用了两种角度和线性评估方法:S-N线与Go-Me线之间的夹角以及S-Go/N-Me比值。对所有样本的20个点进行了评估。首先确定切牙孔的位置。在距切牙孔远中壁4、8、16和24mm处制备副冠状面断层图像,在每个断层图像上,在双侧3mm和6mm距离处确定正中矢状面和旁矢状面区域(共5个点)。在预定点处确定骨皮质板的厚度。结果:平均皮质骨厚度与面高之间存在显著相关性(p<0.01),长面型的皮质骨厚度明显低于短面型。然而,正常面型的皮质骨厚度与长面型和短面型相似。对各点的单独评估显示,在a16点,短面型受试者的皮质骨比长面型和正常面型受试者厚。在长面型的b8点,皮质骨厚度明显低于短面型和正常面型。在d8点,短面型受试者的皮质骨厚度明显高于长面型受试者。结论:在a16点,短面型的皮质骨厚度明显高于正常面型和长面型。长面型受试者在b8点和d8点腭部区域的皮质骨厚度较低,这可能表明这些点在这些受试者中的支抗值较低。