Fukayama Toshiharu, Ozai Yusuke, Shimokawadoko Haruka, Aytemiz Derya, Tanaka Ryou, Machida Noboru, Asakura Tetsuo
a Department of Veterinary Surgery ; Tokyo University of Agriculture & Technology ; Fuchu, Tokyo , Japan.
b Department of Biotechnology ; Tokyo University of Agriculture & Technology; Koganei , Tokyo , Japan.
Organogenesis. 2015;11(3):137-51. doi: 10.1080/15476278.2015.1093268.
Vascular grafts under 5 mm or less in diameter are not developed due to a problem caused by early thrombus formation, neointimal hyperplasia, etc. Bombyx mori silk fibroin (SF) which has biodegradability and tissue infiltration is focused as tube and coating material of vascular grafts. Coating is an important factor to maintain the strength of the anastomotic region of vascular grafts, and to prevent the blood leak from the vascular grafts after implantation. Therefore, in this research, we focused on the SF concentration of the coating solution, and tissue infiltration and remodeling were compared among each SF concentration. Silk poly (-ethylene) glycol diglycidyl ether (PGDE) coating with concentrations of 1.0%, 2.5%, 5.0%, and 7.5% SF were applied for the double-raschel knitted small-sized vessel with 1.5 mm diameter and 1cm in length. The grafts were implanted in the rat abdominal aorta and removed after 3 weeks or 3 months. Vascular grafts patency was monitored by ultrasound, and morphological evaluation was performed by histopathological examination. SF concentration had no significant effects on the patency rate. However, tissue infiltration was significantly higher in the sample of 2.5% SF in 3 weeks, and 1.0% and 2.5% SF in 3 months. Also, in comparison of length inside of the graft, stenosis were not found in 3 weeks, however, found with 5.0% and 7.5% in 3 months. From these results, it is clear that 2.5% SF coating is the most suitable concentration, based on the characteristics of less stenosis, early tissue infiltration, and less neointimal hyperplasia.
直径5毫米及以下的血管移植物由于早期血栓形成、新生内膜增生等问题而未得到发展。具有生物降解性和组织浸润性的家蚕丝素蛋白(SF)作为血管移植物的管材和涂层材料受到关注。涂层是维持血管移植物吻合区域强度以及防止植入后血管移植物血液渗漏的重要因素。因此,在本研究中,我们关注涂层溶液的SF浓度,并比较了不同SF浓度下的组织浸润和重塑情况。将浓度为1.0%、2.5%、5.0%和7.5% SF的丝聚(乙二醇)二缩水甘油醚(PGDE)涂层应用于直径1.5毫米、长度1厘米的双罗纹针织小血管。将移植物植入大鼠腹主动脉,3周或3个月后取出。通过超声监测血管移植物通畅情况,并通过组织病理学检查进行形态学评估。SF浓度对通畅率没有显著影响。然而,在3周时,2.5% SF样本的组织浸润明显更高,在3个月时,1.0%和2.5% SF样本的组织浸润明显更高。此外,比较移植物内部长度,3周时未发现狭窄,但在3个月时,5.0%和7.5% SF样本出现狭窄。从这些结果可以清楚地看出,基于狭窄程度较小、早期组织浸润和新生内膜增生较少的特点,2.5% SF涂层是最合适的浓度。