Eardley-Harris Nathan, Munn Zachary, Cundy Peter J, Gieroba Tom J
1 Joanna Briggs Institute, Faculty of Health Sciences, The University of Adelaide, Australia2 Discipline of Orthopedics and Trauma, Faculty of Health Sciences, The University of Adelaide, Australia3 The Women's and Children's Hospital, North Adelaide, Australia.
JBI Database System Rev Implement Rep. 2015 Nov;13(11):4-16. doi: 10.11124/jbisrir-2015-2338.
REVIEW QUESTION/OBJECTIVE: The objective of this review is to assess the effectiveness of selective thoracic fusion as a form of treatment in adolescent idiopathic scoliosis (AIS). This will be compared with all other forms of operative management for major structural thoracic curves.
Scoliosis is defined as a lateral curvature of the spine of at least 10 degrees, as measured by the Cobb angle. It can be categorized into three broad categories - neuromuscular, congenital and idiopathic. Of these categories, idiopathic is by far the most common, and is a diagnosis of exclusion. Idiopathic scoliosis can then be further broken down into categories based on age of onset. Of these, AIS (children presenting at 10 years of age or older) accounts for 80-85% of cases.Scoliosis curves have a proven complex deformity, consisting of a three-dimensional deformity involving the coronal, sagittal and rotational planes. Each curve (of which there may be many in one patient) can be described with an apex (the vertebra with the greatest lateral distance from the centre of the spine) and the two vertebrae at the end of the curve (named the end vertebrae). The Cobb angle, measured by the intersection of parallel lines from the endplates of the superior and inferior end vertebrae, is the standard way of quantifying the magnitude of scoliosis curves.Major or primary curves are the largest abnormal curves as classified by the Cobb angle. These curves are almost always structural. In addition, secondary or tertiary curves are described as structural if the Cobb angle cannot be reduced to under 25 degrees, on side bending radiographs. Due to the permanent nature of physiological and morphological change of the vertebral bodies and ligaments, structural curves will usually progress as the patient matures, usually at 1 degree per year after maturity. Non-structural curves usually do not progress as the patient matures; instead they are hypothesized to be a product of the body's instinctive nature to provide truncal balance.For many years spinal surgeons have been debating whether a more rigid and straighter spine or a mobile and less straight spine provides better outcomes. The treatment for AIS can include both an operative and non-operative approach. However when the Cobb angle is above 40, the likelihood of curve progression is high and surgical treatment is warranted.Although technology has advanced, the primary goals for operative management have remained constant. The primary goals of surgical treatment in AIS should be to optimize coronal and sagittal correction and avoid further curve progression. This involves not only correction of the major primary curve but also any minor (secondary) curves, while maintaining adequate thoracic kyphosis and lumbar lordosis. Ideally, a balance should be struck between fusing the lowest number of mobile segments and properly correcting the existing deformity. This is where selective spinal fusion has a role to play.The premise of selective thoracic fusion is that after fixation of the primary thoracic curve, there is spontaneous coronal correction of the unfused lumbar curve. Thus the thoracic curve can be exclusively fused to allow for a more mobile lumbar spine. This has been described in studies since the 1950s. However since then, results have varied greatly in the extent of spontaneous lumbar correction. Studies have shown that the degree of spontaneous correction of the lumbar spine is somewhat close to the correction of the thoracic curve; however the extent of optimal correction that can be achieved is uncertain.The alternative to selective thoracic infusion involves complete fusion of both the primary thoracic and secondary lumbar curve in a consecutive series. This can be done via either an anterior or a posterior approach. Complete fusion gives better correction of both curves. It also diminishes the risk of coronal decompensation, adding on phenomenon, junctional kyphosis and eventual revision surgery. However this needs to be calculated against the risk of sagittal decompensation, increased risk of lumbar degeneration and chronic back pain, all of which seem to be more prevalent in patients with fusion of both curves.Another goal of surgical intervention is the need to avoid complications. Examples of complications of selective spinal fusion include: junctional kyphosis, coronal imbalance, adding-on and revision surgery. Junctional kyphosis is described as kyphosis of over 10 degrees more than pre-operative measurements. This is measured by the angle between the inferior end plate of the highest instrumented vertebrae and the superior end plate of the vertebra two levels higher. Coronal imbalance is when the distance between the C7 plumb line and the central sacral vertical line is greater than 2 centimeters. The adding-on phenomenon is described as progression or extension of the primary curve after fusion.In 2001, Lenke et al reported a classification for AIS that has been able to identify those patients who may benefit from a selective spinal fusion (1C, 2C, 5C). A three-tiered approach is used with the Lenke classification system involving curve type, lumbar modifier and sagittal modifier. Firstly the curves of the spinal column (proximal thoracic, main thoracic and thoracolumbar/lumbar) are classified as structural or non-structural before a lumbar modifier (A, B, C) based on the distance from the central sacral vertical line and the lumbar apical vertebra is applied. Further classification is then undertaken measuring the kyphosis of the thoracic curve T5-T12 (-, N, +).Lenke proposed that a selective thoracic fusion could be undertaken when the primary curve is structural and the compensatory lumbar curve is non-structural and that additionally certain radiological criteria were met such as the Cobb angle magnitude, apical vertebral translation and rotation. These are all objective markers that can be accurately measured on plain radiographs, with good inter-and intra-observer reliability.However all surgeons do not routinely accept these treatment guidelines. It has been reported that only approximately 49-67% of experienced surgeons are performing a selective thoracic fusion in Lenke 1C curves. This may be due to the fear of complications (of which the rates are relatively unknown) and well as misunderstanding of how much correction can be achieved by the un-fused compensatory lumbar curve. A search of PubMed, the Cochrane Library, PROSPERO and the JBI Databases of Systematic Reviews and Implementation Reports found no current systematic review assessing the effectiveness of selective thoracic fusion compared to other approaches. As such, the aim of this review is to evaluate and critically appraise available evidence on selective thoracic fusion in order to provide a suitable estimate of the radiological and functional outcomes of this type of surgical intervention as well as the approximate complication rate in order to give patients correct information prior to their providing their informed consent.
综述问题/目标:本综述的目的是评估选择性胸椎融合术作为青少年特发性脊柱侧凸(AIS)一种治疗方式的有效性。将其与治疗主要结构性胸椎侧弯的所有其他手术治疗方式进行比较。
脊柱侧凸定义为脊柱侧弯至少10度(通过Cobb角测量)。它可分为三大类——神经肌肉型、先天性和特发性。在这些类型中,特发性是迄今为止最常见的,且是一种排除性诊断。特发性脊柱侧凸可根据发病年龄进一步细分。其中,AIS(10岁及以上发病的儿童)占病例的80 - 85%。脊柱侧弯曲线存在已证实的复杂畸形,包括涉及冠状面、矢状面和旋转面的三维畸形。每条曲线(一名患者可能有多条)可用一个顶点(距脊柱中心横向距离最大的椎体)以及曲线末端的两个椎体(称为终末椎体)来描述。通过上、下终末椎体终板平行线的交点测量的Cobb角,是量化脊柱侧弯曲线严重程度的标准方法。主要或原发性曲线是按Cobb角分类的最大异常曲线。这些曲线几乎总是结构性的。此外,如果在侧弯X线片上Cobb角不能减小到25度以下,二级或三级曲线也被描述为结构性的。由于椎体和韧带的生理及形态变化具有永久性,结构性曲线通常会随着患者成熟而进展,通常在成熟后每年进展1度。非结构性曲线通常不会随着患者成熟而进展;相反,据推测它们是身体为提供躯干平衡的本能性质的产物。多年来,脊柱外科医生一直在争论更僵硬且更直的脊柱还是更灵活且不太直的脊柱能带来更好的治疗效果。AIS的治疗可包括手术和非手术方法。然而,当Cobb角大于40度时,曲线进展的可能性很高,手术治疗是必要的。尽管技术有所进步,但手术治疗的主要目标一直保持不变。AIS手术治疗的主要目标应该是优化冠状面和矢状面矫正,并避免曲线进一步进展。这不仅涉及矫正主要原发性曲线,还包括任何次要(继发性)曲线,同时保持足够的胸椎后凸和腰椎前凸。理想情况下,应在融合最少活动节段和正确矫正现有畸形之间取得平衡。这就是选择性脊柱融合术发挥作用的地方。选择性胸椎融合术的前提是,在固定原发性胸椎曲线后,未融合的腰椎曲线会自发进行冠状面矫正。因此,可以仅融合胸椎曲线,以使腰椎脊柱更灵活。自20世纪50年代以来,已有研究对此进行描述。然而,从那时起,腰椎自发矫正的程度差异很大。研究表明,腰椎的自发矫正程度与胸椎曲线的矫正程度有些接近;然而,能够实现的最佳矫正程度尚不确定。选择性胸椎融合术之外的另一种方法是连续融合原发性胸椎曲线和继发性腰椎曲线。这可以通过前路或后路进行。完全融合能更好地矫正两条曲线。它还能降低冠状面失代偿、附加现象、交界性后凸和最终翻修手术的风险。然而,这需要与矢状面失代偿的风险、腰椎退变风险增加和慢性背痛相权衡,所有这些在两条曲线都融合的患者中似乎更普遍。手术干预的另一个目标是需要避免并发症。选择性脊柱融合术的并发症示例包括:交界性后凸、冠状面失衡、附加现象和翻修手术。交界性后凸定义为比术前测量值大10度以上的后凸。这通过最高固定椎体的下终板与再高两个节段椎体的上终板之间的角度来测量。冠状面失衡是指C7铅垂线与骶骨中心垂直线之间的距离大于2厘米。附加现象是指融合后原发性曲线的进展或延伸。2001年,Lenke等人报告了一种AIS分类方法,该方法能够识别那些可能从选择性脊柱融合术(1C、2C、5C)中受益的患者。Lenke分类系统采用三层方法,涉及曲线类型、腰椎修正因素和矢状面修正因素。首先,在应用基于距骶骨中心垂直线的距离和腰椎顶椎的腰椎修正因素(A、B、C)之前,将脊柱的曲线(近端胸椎、主要胸椎和胸腰段/腰椎)分类为结构性或非结构性。然后进一步分类,测量胸椎曲线T5 - T12的后凸( - 、N、 + )。Lenke提出,当原发性曲线是结构性的且代偿性腰椎曲线是非结构性的,并且满足某些放射学标准,如Cobb角大小、顶椎平移和旋转时,可以进行选择性胸椎融合术。这些都是可以在普通X线片上准确测量的客观指标,观察者间和观察者内的可靠性都很好。然而,并非所有外科医生都常规接受这些治疗指南。据报道,只有大约49 - 67%有经验的外科医生在Lenke 1C曲线中进行选择性胸椎融合术。这可能是由于对并发症的担忧(其发生率相对未知)以及对未融合的代偿性腰椎曲线能实现多少矫正存在误解。检索PubMed、Cochrane图书馆、PROSPERO以及系统评价和实施报告的JBI数据库发现,目前没有系统评价评估选择性胸椎融合术与其他方法相比的有效性。因此,本综述的目的是评估和批判性评价关于选择性胸椎融合术的现有证据,以便对这种手术干预的放射学和功能结果以及大致并发症发生率提供合适的估计,以便在患者提供知情同意之前为他们提供正确信息。