Suppr超能文献

核糖体肽键形成过程中P位点结合供体的反应活性。

Reactivity of the P-site-bound donor in ribosomal peptide-bond formation.

作者信息

Synetos D, Coutsogeorgopoulos C

机构信息

Laboratory of Biochemistry, School of Medicine, University of Patras, Greece.

出版信息

Eur J Biochem. 1989 Sep 1;184(1):47-52. doi: 10.1111/j.1432-1033.1989.tb14988.x.

Abstract

The puromycin reaction, catalyzed by the ribosomal peptidyltransferase, has been carried out so as to make the definition of two distinct parameters of this reaction possible. These are (a) the final degree of the reaction which gives the proportion of peptidyl (P)-site binding of the donor and (b) the reactivity of the donor substrate expressed as an apparent rate constant (kobs). This kobs varies with the concentration of puromycin; the maximal value (k3) of the kobs, at saturating concentrations of puromycin, gives the reactivity of the donor independently of the concentrations of both the donor and puromycin. k3 is also a measure of the activity of peptidyltransferase expressed as its catalytic rate constant (kcat). If we assume that the puromycin-reactive donor is bound at the ribosomal P site, we observe the following, depending on the conditions of the experiment: the proportion of P-site binding of the donor substrates AcPhe-tRNA or fMet-tRNA can be the same and close to 100%, while there is a tenfold increase in the reactivity of the donor (k3 = 0.8 min-1 versus 8.3 min-1). On the other hand there are conditions, under which the proportion of P-site binding increases from 30% to 100% while k3 remains low and equal to 0.8 min-1. Using the puromycin reaction it was also found that an increase of Mg2+ from 10 mM to 20 mM reduces the reactivity of the donor and, hence, the activity of peptidyltransferase, provided that this change in Mg2+ occurs during the binding of the donor but not when it occurs during peptide bond formation per se. The fact that the donor substrate may exist in various states of reactivity in this cell-free system raises the possibility that the rate of peptide bond formation may not be uniform during protein synthesis.

摘要

由核糖体肽基转移酶催化的嘌呤霉素反应已经得以进行,从而有可能定义该反应的两个不同参数。这两个参数分别是:(a) 反应的最终程度,它给出了供体在肽基(P)位点结合的比例;(b) 供体底物的反应活性,以表观速率常数(kobs)表示。这个kobs随嘌呤霉素浓度而变化;在嘌呤霉素饱和浓度下,kobs的最大值(k3)给出了供体的反应活性,而与供体和嘌呤霉素的浓度无关。k3也是以催化速率常数(kcat)表示的肽基转移酶活性的一种度量。如果我们假设与嘌呤霉素反应的供体结合在核糖体P位点,根据实验条件我们观察到以下情况:供体底物AcPhe-tRNA或fMet-tRNA在P位点结合的比例可以相同且接近100%,而供体的反应活性增加了10倍(k3 = 0.8分钟-1对8.3分钟-1)。另一方面,在某些条件下,P位点结合的比例从30%增加到100%,而k3仍然很低,等于0.8分钟-1。利用嘌呤霉素反应还发现,将Mg2+浓度从10 mM增加到20 mM会降低供体的反应活性,从而降低肽基转移酶的活性,前提是Mg2+的这种变化发生在供体结合期间,而不是在肽键形成本身的过程中。在这个无细胞系统中,供体底物可能以各种反应活性状态存在,这一事实增加了蛋白质合成过程中肽键形成速率可能不均匀的可能性。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验