Janusz Piotr, Tyrakowski Marcin, Monsef Jad Bou, Siemionow Kris
Department of Orthopaedic Surgery, University of Illinois at Chicago, 835 South Wolcott Ave, Room E-270, Chicago, IL, 60612, USA.
Department of Spine Disorders and Pediatric Orthopedics, University of Medical Sciences, Poznan, Poland.
Eur Spine J. 2016 Nov;25(11):3622-3629. doi: 10.1007/s00586-016-4458-8. Epub 2016 Mar 3.
Pelvic incidence (PI), pelvic tilt (PT) and sacral slope (SS) are important parameters in sagittal spine alignment evaluation. The measurements are a projection of the three-dimensional pelvis onto a two-dimensional radiograph and they may be influenced by orientation of the pelvis. The aim of this study was to assess the influence of pelvic rotation in the coronal plane (CPR) on radiographic accuracy of PI, PT, and SS measurements.
Radiological evaluation of the CPR angel was performed on 1 radiological phantom. The radiographs were taken in 5° CPR increments over a range of 0°-45° (evaluated with a digital protractor). On each of the lateral radiograph, PI, PT, and SS were measured three times by three independent researchers. The lowest CPR that changed PI, PT, or SS by ≥6° (the highest reported error of measurement of these parameters) was considered as unacceptable. Next, CPR was calculated based on the distance between femoral heads (FHD). The agreement of the calculated and measured CPR was quantified by the intraclass correlation coefficient (ICC) and the median error for a single measurement (SEM), with value 0.75 considered as excellent agreement.
PI, PT and SS could be measured with an acceptable error of 6° on radiographs with up to 20° pelvic rotation. From 20° CPR onwards the S1 endplate was distorted, that makes the measurements of PI, PT and SS questionable. There was an excellent agreement between CPR measured with a protractor and calculated based on FHD with ICC of 0.99 and SEM of 1.1°.
Rotation of the pelvis in the coronal plane during acquisition of radiographs influences PI, PT and SS measurements. Substantial error of PI, PT and SS measurements occurs with CPR of more than 20° which is equivalent to a lower limb discrepancy of 5.2 cm. CPR may be calculated while acquiring the radiograph. Further evaluation of the influence of CPR on spinopelvic parameters with a larger sample would be valuable.
骨盆入射角(PI)、骨盆倾斜角(PT)和骶骨倾斜角(SS)是矢状面脊柱排列评估中的重要参数。这些测量值是三维骨盆在二维X线片上的投影,可能会受到骨盆方向的影响。本研究的目的是评估冠状面骨盆旋转(CPR)对PI、PT和SS测量的X线片准确性的影响。
对1个放射学模型进行CPR角度的放射学评估。在0°至45°范围内以5°的CPR增量拍摄X线片(用数字量角器评估)。在每张侧位X线片上,由3名独立研究人员对PI、PT和SS进行3次测量。使PI、PT或SS改变≥6°(这些参数报道的最高测量误差)的最低CPR被认为是不可接受的。接下来,根据股骨头之间的距离(FHD)计算CPR。通过组内相关系数(ICC)和单次测量的中位数误差(SEM)对计算得到的CPR和测量得到的CPR之间的一致性进行量化,ICC值0.75被认为是极好的一致性。
在骨盆旋转角度达20°的X线片上,PI、PT和SS能够以6°的可接受误差进行测量。从CPR 20°起,S1终板变形,这使得PI、PT和SS的测量结果存疑。用量角器测量的CPR与基于FHD计算得到的CPR之间具有极好的一致性,ICC为0.99,SEM为1.1°。
拍摄X线片时冠状面骨盆旋转会影响PI、PT和SS的测量。当CPR超过20°时,PI、PT和SS测量会出现较大误差,这相当于下肢长度差异5.2厘米。在拍摄X线片时可以计算CPR。用更大样本进一步评估CPR对脊柱骨盆参数的影响将很有价值。