Suppr超能文献

CdS 量子点尺寸的大分布对光催化制氢过程中进入 TiO2 纳米管的电荷转移相互作用的影响。

Effects of the large distribution of CdS quantum dot sizes on the charge transfer interactions into TiO2 nanotubes for photocatalytic hydrogen generation.

机构信息

Universidade Federal de Pernambuco (UFPE), Recife, PE, Brazil. Centro de Tecnologias Estratégicas do Nordeste (CETENE), Recife, PE, Brazil.

出版信息

Nanotechnology. 2016 Jul 15;27(28):285401. doi: 10.1088/0957-4484/27/28/285401. Epub 2016 Jun 2.

Abstract

Hydrogen fuels generated by water splitting using a photocatalyst and solar irradiation are currently gaining the strength to diversify the world energy matrix in a green way. CdS quantum dots have revealed a hydrogen generation improvement when added to TiO2 materials under visible-light irradiation. In the present paper, we investigated the performance of TiO2 nanotubes coupled with CdS quantum dots, by a molecular bifunctional linker, on photocatalytic hydrogen generation. TiO2 nanotubes were obtained by anodization of Ti foil, followed by annealing to crystallize the nanotubes into the anatase phase. Afterwards, the samples were sensitized with CdS quantum dots via an in situ hydrothermal route using 3-mercaptopropionic acid as the capping agent. This sensitization technique permits high loading and uniform distribution of CdS quantum dots onto TiO2 nanotubes. The XPS depth profile showed that CdS concentration remains almost unchanged (homogeneous), while the concentration relative to the sulfate anion decreases by more than 80% with respect to the initial value after ∼100 nm in depth. The presence of sulfate anions is due to the oxidation of sulfide and occurs in greater proportion in the material surface. This protection for air oxidation inside the nanotubular matrix seemingly protected the CdS for photocorrosion in sacrificial solution leading to good stability properties proved by long duration, stable photocurrent measurements. The effect of the size and the distribution of sizes of CdS quantum dots attached to TiO2 nanotubes on the photocatalytic hydrogen generation were investigated. The experimental results showed three different behaviors when the reaction time of CdS synthesis was increased in the sensitized samples, i.e. similar, deactivation and activation effects on the hydrogen production with regard to TiO2 nanotubes. The deactivation effect was related to two populations of sizes of CdS, where the population with a shorter band gap acts as a trap for the electrons photogenerated by the population with a larger band gap. Electron transfer from CdS quantum dots to TiO2 semiconductor nanotubes was proven by the results of UPS measurements combined with optical band gap measurements. This property facilitates an improvement of the visible-light hydrogen evolution rate from zero, for TiO2 nanotubes, to approximately 0.3 μmol cm(-2) h(-1) for TiO2 nanotubes sensitized with CdS quantum dots.

摘要

目前,通过光催化剂和太阳辐射分解水产生的氢气燃料正逐渐增强以绿色方式使世界能源结构多样化。在可见光照射下,CdS 量子点被添加到 TiO2 材料中时,其制氢性能得到了提高。在本文中,我们通过分子双功能链接剂研究了 TiO2 纳米管与 CdS 量子点结合在光催化制氢方面的性能。TiO2 纳米管通过 Ti 箔的阳极氧化获得,然后进行退火处理使纳米管结晶为锐钛矿相。之后,通过使用 3-巯基丙酸作为封端剂的原位水热路线将 CdS 量子点敏化到纳米管上。这种敏化技术允许 CdS 量子点高负载和均匀分布在 TiO2 纳米管上。XPS 深度剖析表明,CdS 浓度基本保持不变(均匀),而相对于初始值,硫酸根阴离子的浓度在深度为 100nm 左右时降低了 80%以上。硫酸根阴离子的存在是由于硫化物的氧化,并且在材料表面以更大的比例存在。这种对纳米管状基质内空气氧化的保护似乎防止了 CdS 在牺牲溶液中的光腐蚀,从而通过长时间、稳定的光电流测量证明了良好的稳定性。研究了附着在 TiO2 纳米管上的 CdS 量子点的尺寸和分布对光催化制氢的影响。实验结果表明,在敏化样品中增加 CdS 合成反应时间时,有三种不同的行为,即相对于 TiO2 纳米管,对氢气生成具有相似、失活和激活作用。失活效应与 CdS 的两种尺寸群体有关,其中带隙较小的群体充当带隙较大群体产生的光生电子的陷阱。从 UPS 测量结果与光学能带隙测量结果相结合的结果证明了电子从 CdS 量子点转移到 TiO2 半导体纳米管。这种特性有助于将 TiO2 纳米管的可见光制氢率从零提高到约 0.3μmolcm(-2)h(-1),对于用 CdS 量子点敏化的 TiO2 纳米管。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验