Suppr超能文献

[传统与改良牙冠延长术及桩核修复对上颌中切牙冠根折治疗的有限元分析]

[Finite element analysis of the maxillary central incisor with traditional and modified crown lengthening surgery and post-core restoration in management of crown-root fracture].

作者信息

Zhen M, Wei Y P, Hu W J, Rong Q G, Zhang H

机构信息

Department of Periodontology, Peking University School and Hospital of Stomatology, Beijing 100081, China.

Department of Mechanics and Engineering Science, College of Engineering, Peking University, Beijing 100871, China.

出版信息

Zhonghua Kou Qiang Yi Xue Za Zhi. 2016 Jun;51(6):362-7. doi: 10.3760/cma.j.issn.1002-0098.2016.06.009.

Abstract

OBJECTIVE

To construct three-dimensional finite element models with modified crown lengthening surgery and post-core restoration in management of various crown-root fracture types, to investigate the intensity and distribution of stressin models mentioned above, and to compare and analyze the indications of traditional and modified crown lengthening surgeries from the mechanic point of view.

METHODS

Nine three-dimensional finite element models with modified crown lengthening surgery and post-core restoration were established and analyzed by micro-CT scanning technique, dental impression scanner, Mimics 10.0, Geomagic studio 9.0 and ANSYS 14.0 software. The von Mises stress of dentin, periodontal ligament, alveolar bone, post and core, as well as the periodontal ligament area and threshold limit value were calculated and compared with the findings of traditional crown lengthening models which had been published earlierby our research group.

RESULTS

The von Mises stress intensity of modified crown lengthening models were: dentin>post>core>alveolar bone>periodontal ligament. The maximum von Mises stress of dentin(44.37-80.58 MPa)distributed in lingual central shoulder. The periodontal ligament area of the modified crown lengthening surgery was reduced by 6% to 28%, under the same crown-root fracture conditions, the periodontal ligament area of modified crown lengthening models was larger than that of the traditional crown lengthening models. In modified crown lengthening surgery models, the von Mises stress of periodontal ligament of B3L1m, B3L2m, B3L3m models exceeded their limit values, however, the von Mises stress of periodontal ligament of the B2L2c, B2L3c, B3L1c, B3L2c, B3L3c models exceeded their limit values in traditional crown lengthening surgery models.

CONCLUSIONS

The modified crown lengthening surgery conserves more periodontal supporting tissues, which facilitates the long-term survival of teeth. The indication of modified crown lengthening surgery is wider than traditional method. The maxillary central incisors with labial fracture at gingival margin level and with palatal fracture at or below the alveolar crest level are not the indication of the crown lengthening surgery.

摘要

目的

构建不同冠根折类型采用改良冠延长术及桩核修复的三维有限元模型,研究上述模型应力的大小及分布情况,并从力学角度比较分析传统冠延长术与改良冠延长术的适应证。

方法

采用显微CT扫描技术、口腔印模扫描仪、Mimics 10.0、Geomagic studio 9.0及ANSYS 14.0软件,建立9个改良冠延长术及桩核修复的三维有限元模型并进行分析。计算牙本质、牙周膜、牙槽骨、桩核的von Mises应力以及牙周膜面积和阈值,并与本研究组前期发表的传统冠延长模型的结果进行比较。

结果

改良冠延长模型的von Mises应力大小顺序为:牙本质>桩>核>牙槽骨>牙周膜。牙本质的最大von Mises应力(44.37 - 80.58 MPa)分布于舌侧中央肩台处。改良冠延长术的牙周膜面积减少了6%至28%,在相同冠根折条件下,改良冠延长模型的牙周膜面积大于传统冠延长模型。在改良冠延长术模型中,B3L1m、B3L2m、B3L3m模型牙周膜的von Mises应力超过其阈值,而在传统冠延长术模型中,B2L2c、B2L3c、B3L1c、B3L2c、B3L3c模型牙周膜的von Mises应力超过其阈值。

结论

改良冠延长术保留了更多的牙周支持组织,有利于牙齿的长期存活。改良冠延长术的适应证比传统方法更广泛。牙龈缘水平唇侧折断且牙槽嵴水平或以下腭侧折断的上颌中切牙不是冠延长术的适应证。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验