Radwin R G, VanBergeijk E, Armstrong T J
Ergonomics. 1989 Jun;32(6):655-74. doi: 10.1080/00140138908966140.
Surface electromyography was used for studying the effects of torque reaction force acting against the hand, on forearm muscle activity and grip force for five subjects operating right angle, air shut-off nutrunners. Four tools having increasing spindle torque were operated using short and long torque reaction times. Nutrunner spindle torque ranged between 30 Nm and 100 Nm. Short torque reaction time was considered 0.5 s while long torque reaction time was 2 s. Peak horizontal force was the greatest component of the reaction force acting against the hand and accounted for more than 97% of the peak resultant hand force. Peak hand force increased from 89 N for the smallest tool to 202 N for the largest tool. Forearm muscle rms EMG, scaled for grip force, indicated average flexor activity during the Torque-reaction phase was more than four times greater than the Pre-start and Post Shut-off phases, and two times greater than the Run-down phase. Flexor EMG activity during the Torque-reaction phase increased for increasing tool peak spindle torque. Average flexor rms EMG activity, scaled for grip force, during the Torque-reaction phase increased from 372 N for the 30 Nm nutrunner to 449 N for the 100 Nm nutrunner. Flexor rms EMG activity averaged during the Torque-reaction phase and scaled for grip force was 390 N for long torque reaction times and increased to 440 N for short torque reaction times. Flexor rms EMG integrated over the torque reaction phase was 839 Ns for long torque reaction times and decreased to 312 Ns for short torque reaction times. The average latency between tool spindle torque onset and peak initial flexor rms EMG for long torque reaction times was 294 ms which decreased to 161 ms for short torque reaction times. The average latency between peak tool spindle torque, just prior to tool shut-off, and peak final rms EMG for long torque reaction times was 97 ms for flexors and 188 ms for extensors, which decreased for short torque reaction times to 47 ms for flexors and 116 ms for extensors. The results suggest that right angle nutrunner torque reaction forces can affect extrinsic hand muscles in the forearm, and hence grip exertions, by way of a reflex response.(ABSTRACT TRUNCATED AT 400 WORDS)
表面肌电图被用于研究作用于手部的扭矩反作用力对五名操作直角气动关闭螺母扳手的受试者前臂肌肉活动和握力的影响。使用四种具有递增主轴扭矩的工具,分别采用短扭矩反应时间和长扭矩反应时间进行操作。螺母扳手的主轴扭矩范围在30牛米至100牛米之间。短扭矩反应时间设定为0.5秒,长扭矩反应时间设定为2秒。峰值水平力是作用于手部的反作用力的最大组成部分,占峰值手部合力的97%以上。峰值手部力从最小工具的89牛增加到最大工具的202牛。按握力进行缩放的前臂肌肉均方根肌电图显示,在扭矩反应阶段的平均屈肌活动比启动前和关闭后阶段大四倍多,比减速阶段大两倍。随着工具峰值主轴扭矩的增加,扭矩反应阶段的屈肌肌电图活动增加。按握力进行缩放,扭矩反应阶段的平均屈肌均方根肌电图活动从30牛米螺母扳手的372牛增加到100牛米螺母扳手的449牛。按握力进行缩放,扭矩反应阶段的屈肌均方根肌电图活动在长扭矩反应时间下平均为390牛,在短扭矩反应时间下增加到440牛。在扭矩反应阶段积分的屈肌均方根肌电图在长扭矩反应时间下为839牛秒,在短扭矩反应时间下降至312牛秒。长扭矩反应时间下,工具主轴扭矩开始到初始屈肌均方根肌电图峰值的平均潜伏期为294毫秒,短扭矩反应时间下降至161毫秒。在工具关闭前,长扭矩反应时间下,峰值工具主轴扭矩到最终屈肌均方根肌电图峰值的平均潜伏期,屈肌为97毫秒,伸肌为188毫秒,短扭矩反应时间下,屈肌降至47毫秒,伸肌降至116毫秒。结果表明,直角螺母扳手的扭矩反作用力可通过反射反应影响前臂的手部外在肌肉,进而影响握力。(摘要截断于400字)