Chang Zhu Tan Institute of Two-oriented Social, Hunan University of Technology, Zhuzhou 412007, China.
University of South China, Hengyang 421001, China.
Waste Manag. 2017 Apr;62:118-124. doi: 10.1016/j.wasman.2016.11.022. Epub 2016 Nov 22.
In order to form a modified solid recovered fuel (SRF) with low chlorine content, high calorific value and well combustion performance, low temperature microwave irradiation was applied to remove the chlorine of the organochloride waste mixture before they were mixed to form SRF. The optimizing conditions of final temperature, microwave absorbents and heating rate were also detected to obtain high dechlorination ratio and high ratio of hydrogen chloride (HCl) to volatiles. In the temperature range of 220-300°C, 280°C would be chose as the optimal low microwave modified temperature concerning at which the dechlorination ratio was high and ratio of HCl to volatiles was relatively high as well; The use of microwave absorbents of graphite and silicon carbide (SiC) had a pronounced effect on the dechlorination of organochloride waste mixture, and the dechlorination ratio was increased significantly which could be reached to 87%, almost 20% higher than absorbent absent sample; The heating rate should set be not too fast nor too slow, and there was no big difference between the heating rate of 13°C/min and 15°C/min; The content of Cl of modified SRF is dramatically decreased and reaches to a low level 0.328%. Hence, the modified SRF can be ascended from the third class to the second class according to the Finland chlorine Classes I-III. Moreover, the combustibility of modified SRF was substantial improved compared to the traditional SRF. The low heating value was almost 20.56MJ/kg which is close to the LHV of lignite coal and bituminous coal in China, and it increased by 60% over that of traditional SRF. Removing chlorine of organochloride waste mixture before they are mixed with other kinds of combustible waste to form a modified SRF which is expected to be an alternative fuel for combustion in the future.
为了形成一种氯含量低、热值高、燃烧性能好的改性固体回收燃料 (SRF),在将有机氯废物混合物与其他可燃废物混合形成 SRF 之前,应用低温微波辐照去除有机氯废物混合物中的氯。还检测了最终温度、微波吸收剂和加热速率的优化条件,以获得高脱氯率和高氯化氢 (HCl) 与挥发物的比例。在 220-300°C 的温度范围内,选择 280°C 作为最佳低温微波改性温度,因为在此温度下脱氯率高,HCl 与挥发物的比例也相对较高;石墨和碳化硅 (SiC) 等微波吸收剂的使用对有机氯废物混合物的脱氯有显著影响,脱氯率显著提高,可达 87%,比无吸收剂样品高近 20%;加热速率不应太快也不应太慢,加热速率为 13°C/min 和 15°C/min 之间没有太大区别;改性 SRF 的氯含量显著降低,达到低水平 0.328%。因此,根据芬兰氯类 I-III,改性 SRF 可从第三类提升至第二类。此外,与传统 SRF 相比,改性 SRF 的燃烧性能有了显著提高。低热值几乎达到 20.56MJ/kg,接近中国褐煤和烟煤的 LHV,比传统 SRF 提高了 60%。在将有机氯废物混合物与其他可燃废物混合形成改性 SRF 之前,去除有机氯废物混合物中的氯,有望成为未来燃烧的替代燃料。