Gordon K R, Perl M, Levy C
Department of Biological Sciences, Florida International University, Miami.
Bone. 1989;10(4):303-12. doi: 10.1016/8756-3282(89)90068-9.
Mice were used as a model system to correlate loading, changes in cortical and trabecular bone growth and remodeling, and differences in breaking strength of the whole femur. BALB/c mice were raised for 30 days, starting at day 14, under three conditions of loading or exercise: (a) normal exercise control (NE), (b) 4 x normal gravity for a total of one h/day in addition to normal exercises (HG), and (c) chronic digging and burrowing (high-litter cage) (HL). Results indicate that both HG and HL groups significantly increased the cortical cross-sectional area of the mid-shaft of the femur, the moment of inertia in the antero-posterior direction at the mid-shaft, anterior wall thickness of the midshaft cross section, and changed the architecture of trabecular bone in the proximal one-third of the femur. The extent of these structural changes, however, was unique in each group. The HG group (high-intensity, short duration loading) demonstrated the greatest structural changes in the moment of inertia in the antero-posterior direction, which increased by 44% over the control (p less than .001), and in the architecture of trabecular bone. The HL group (lower-intensity, chronic exercise), demonstrated the greatest structural change in cortical bone cross-sectional area, which increased by 27% (p less than .0001). Despite the differences in loading and structural changes in the HG and HL groups, the breaking strength of the whole femur for both groups was approximately 64% greater than the controls (p less than .0001). A mechanical analysis of our data revealed that for our tests the contribution of bending to the total stress on the shaft may be over 50 times greater than that of either compression or tension. Further, the change in the geometry of the cortical bone may account for only approximately 50% of the increase in breaking strength; the remaining increase must be accounted for by changes in material properties and/or placement of trabeculae within the lumen of the shaft.
小鼠被用作模型系统,以关联负荷、皮质骨和小梁骨生长与重塑的变化以及整个股骨抗断强度的差异。BALB/c小鼠从第14天开始饲养30天,处于三种负荷或运动条件下:(a)正常运动对照(NE),(b)除正常运动外,每天总共1小时承受4倍正常重力(HG),以及(c)长期挖掘和打洞(高垫料笼)(HL)。结果表明,HG组和HL组均显著增加了股骨中轴的皮质横截面积、中轴前后方向的惯性矩、中轴横截面的前壁厚度,并改变了股骨近端三分之一处小梁骨的结构。然而,这些结构变化的程度在每组中都是独特的。HG组(高强度、短时间负荷)在前后方向的惯性矩以及小梁骨结构方面表现出最大的结构变化,与对照组相比增加了44%(p<0.001)。HL组(低强度、长期运动)在皮质骨横截面积方面表现出最大的结构变化,增加了27%(p<0.0001)。尽管HG组和HL组在负荷和结构变化上存在差异,但两组整个股骨的抗断强度均比对照组大约高64%(p<0.0001)。对我们数据的力学分析表明,对于我们的测试,弯曲对轴上总应力的贡献可能比压缩或拉伸大50倍以上。此外,皮质骨几何形状的变化可能仅占抗断强度增加的约50%;其余的增加必须归因于材料特性的变化和/或小梁在髓腔内的排列。