Cancienne Jourdan M, Werner Brian C, Burrus M Tyrrell, Kandil Abdurrahman, Conte Evan J, Gwathmey Frank W, Miller Mark D
Department of Orthopaedic Surgery, University of Virginia Health System, Charlottesville, Virginia.
J Knee Surg. 2017 Nov;30(9):920-924. doi: 10.1055/s-0037-1599252. Epub 2017 Mar 10.
The purpose of this study was to use fluoroscopy to measure the distance between the transseptal portal and the popliteal artery under arthroscopic conditions with an intact posterior knee capsule, and to determine the difference between 90 degrees of knee flexion and full extension. The popliteal artery of eight fresh-frozen cadaveric knees was dissected and cannulated proximal to the knee joint. The posterolateral, posteromedial, and transseptal portals were then established at 90 degrees of flexion. A 4-mm switching stick was placed through the transseptal portal, and barium contrast was injected into the popliteal artery. A lateral fluoroscopic image was taken with the knee in 90 degrees of flexion and full extension, and the distance between the popliteal artery and the switching stick was measured and compared using a paired -test. In knee flexion, the average distance between the transseptal portal and the anterior aspect of the popliteal artery for the eight cadaveric specimens was 12.0 mm ± 3.3 mm; in extension, this decreased to 9.0 mm ± 2.7 mm. The distance between the transseptal portal and popliteal artery was significantly higher at 90 degrees of knee flexion as compared with extension ( = 0.0005). The transseptal posterior knee arthroscopic portal must be carefully created due to the close proximity to the popliteal artery, and may be closer to the artery than previously reported in specimens with an intact posterior knee capsule. Creating the portal with the knee in flexion significantly displaces the popliteal artery away from the portal reducing the risk of arterial injury.
本研究的目的是在膝关节后囊完整的关节镜检查条件下,使用荧光透视法测量经隔门与腘动脉之间的距离,并确定膝关节屈曲90度和完全伸展之间的差异。对8个新鲜冷冻尸体膝关节的腘动脉进行解剖,并在膝关节近端插管。然后在屈曲90度时建立后外侧、后内侧和经隔门。将一根4毫米的转换棒通过经隔门插入,将钡剂造影剂注入腘动脉。在膝关节屈曲90度和完全伸展时拍摄外侧荧光透视图像,并使用配对t检验测量和比较腘动脉与转换棒之间的距离。在膝关节屈曲时,8个尸体标本的经隔门与腘动脉前侧之间的平均距离为12.0毫米±3.3毫米;在伸展时,该距离降至9.0毫米±2.7毫米。与伸展相比,膝关节屈曲90度时经隔门与腘动脉之间的距离明显更高(P = 0.0005)。由于与腘动脉距离很近,经隔后膝关节镜检查门必须小心创建,并且在膝关节后囊完整的标本中可能比以前报道的更靠近动脉。在膝关节屈曲时创建门会显著使腘动脉远离门,从而降低动脉损伤的风险。