Department of Chemical Engineering and Biotechnology, University of Cambridge, Pembroke Street, Cambridge CB2 3RA, UK.
Soft Matter. 2017 Apr 19;13(16):2952-2961. doi: 10.1039/c6sm02811j.
Gelatin gels are increasingly involved in many industrial applications due to several advantages including cost efficiency and biocompatibility. Generally, their production requires the use of aqueous solvents, which cause significant swelling, due to the ability of solvent molecules to penetrate through the gel microstructure and increase its volume. Since swelling mechanisms and their effect on the gel structure are not fully understood, further investigations are required. In this work, we combine macroscopic measurements of the swelling ratio (SR) with Nuclear Magnetic Resonance (NMR) and Confocal Laser Scanning Microscopy (CLSM) to investigate changes in the gelatin structure as a function of both polymer concentration and swelling time. SR values increase as a function of time until a maximum is reached and then show a slight drop for all the gelatin concentrations after 24 h swelling time, probably due to a network relaxation process. NMR allows determination of mass transport and molecular dynamics of water inside the gelatin pores, while CLSM is used to visualize the penetration of tracers (polystyrene microbeads) with a diameter much larger than the gel pores. Structural parameters, such as average pore size and tortuosity, are estimated. In particular, the pore size decreases for higher polymer concentration and increases during swelling, until reaching a maximum, and then dropping at longer times. The penetration of tracers provides evidence of the heterogeneity of the gel structure and shows that single microcarriers can be loaded in gelatin gels upon swelling.
明胶凝胶由于成本效益和生物相容性等优点,在许多工业应用中越来越受欢迎。通常,它们的生产需要使用水溶剂,由于溶剂分子能够穿透凝胶微结构并增加其体积,这会导致明显的溶胀。由于对溶胀机制及其对凝胶结构的影响尚未完全了解,因此需要进一步研究。在这项工作中,我们将溶胀比 (SR) 的宏观测量与核磁共振 (NMR) 和共聚焦激光扫描显微镜 (CLSM) 相结合,研究了聚合物浓度和溶胀时间对明胶结构的变化。SR 值随时间增加,直到达到最大值,然后在 24 小时溶胀时间后,所有明胶浓度的 SR 值都略有下降,这可能是由于网络松弛过程。NMR 可用于确定明胶孔内水的质量传递和分子动力学,而 CLSM 则用于可视化直径比凝胶孔大得多的示踪剂(聚苯乙烯微球)的渗透。可以估计结构参数,如平均孔径和迂曲度。特别是,对于较高的聚合物浓度,孔径会减小,并且在溶胀过程中会增加,直到达到最大值,然后在较长时间后下降。示踪剂的渗透证明了凝胶结构的异质性,并表明在溶胀时可以将单个微载体装入明胶凝胶中。