Department of Energy and Mineral Engineering, G3 Center and Energy Institute, The Pennsylvania State University, University Park, Old Main, PA, 16802, USA.
Solid State Physics Division, Bhabha Atomic Research Centre, Mumbai, 400094, India.
Sci Rep. 2017 Jun 19;7(1):3840. doi: 10.1038/s41598-017-04110-z.
Microbial enhanced coalbed methane (ME-CBM) recovery is critically examined as a viable technology for natural gas recovery from coalbed methane (CBM) reservoirs. Since the majority of gas-in-place (GIP) is stored as an adsorbed phase in fine pores of coal matrix, the nano-pore structure directly influences gas storage and transport properties. Only limited studies have quantified the alteration of the nano-pore structure due to ME-CBM treatment. This study examines the evolution of the pore structure using a combination of small angle X-ray scattering (SAXS), low-pressure N and CO adsorption (LPGA) and high-pressure methane adsorption methods. The results show that the surface fractal dimension decreases for the two bioconverted coals compared to the untreated coal. After bio-treatment, the mesopore surface area and pore volume decrease with the average pore diameter increases, while the micropore surface area increases with pore volume decreases. Both inaccessible meso-/micropore size distributions decrease after bioconversion, while the accessible micropore size distribution increases, making a portion of closed micropore network accessible. In addition, the methane adsorption capacities increase after bio-treatment, which is confirmed by the increase of micropore surface area. A conceptual physical model of methanogenesis is proposed based on the evolution of the pore structure.
微生物强化煤层气(ME-CBM)采气被视为从煤层气(CBM)储层中回收天然气的可行技术而受到严格审查。由于大部分原地天然气(GIP)以吸附相储存在煤基质的微孔中,因此纳米孔结构直接影响气体储存和传输性能。只有有限的研究量化了 ME-CBM 处理对纳米孔结构的改变。本研究使用小角 X 射线散射(SAXS)、低压 N 和 CO 吸附(LPGA)以及高压甲烷吸附方法相结合来研究孔隙结构的演变。结果表明,与未处理的煤相比,两种生物转化煤的表面分形维数降低。生物处理后,中孔表面积和孔体积随平均孔径增大而减小,而微孔表面积随孔体积减小而增大。生物转化后,不可接近的中/微孔尺寸分布减小,而可接近的微孔尺寸分布增加,使一部分封闭的微孔网络变得可接近。此外,生物处理后甲烷吸附能力增加,这可以通过增加微孔表面积得到证实。根据孔隙结构的演变,提出了一种甲烷生成的概念物理模型。