Suppr超能文献

胸主动脉腔内修复术中血管内超声与中心线计算机断层扫描测定的主动脉直径比较。

Comparison of intravascular ultrasound- and centerline computed tomography-determined aortic diameters during thoracic endovascular aortic repair.

作者信息

Han Sukgu M, Elsayed Ramsey S, Ham Sung W, Mahajan Anuj, Fleischman Fernando, Rowe Vincent L, Cunningham Mark J, Weaver Fred A

机构信息

Comprehensive Aortic Center, Keck School of Medicine, University of Southern California, Los Angeles, Calif.

Comprehensive Aortic Center, Keck School of Medicine, University of Southern California, Los Angeles, Calif.

出版信息

J Vasc Surg. 2017 Oct;66(4):1184-1191. doi: 10.1016/j.jvs.2017.03.445. Epub 2017 Jun 22.

Abstract

BACKGROUND

Accurate sizing of stent grafts during thoracic endovascular aortic repair (TEVAR) is critical for a successful outcome. Centerline measurements using three-dimensional reconstruction of preoperative computed tomography angiography (CTA) is the current standard for stent graft sizing. However, this technique is predicated on an idealized straightened aorta and does not account for the variability in the aortic diameter during the cardiac cycle or the overall status of the patient's volume. Intravascular ultrasound (IVUS) offers real-time cross-sectional imaging of the aorta orthogonal to the support wire, thereby providing an adjunctive method for aortic diameter determination at the time of TEVAR.

METHODS

A retrospective review was performed on all patients who underwent TEVAR for nontraumatic aortic pathology from July 2015 to December 2015. Preoperative CTA images were reconstructed on a dedicated three-dimensional workstation. CTA centerline aortic diameter measurements were performed in major and minor axes at 1-cm intervals from the left subclavian origin to 20 cm distally. The IVUS images were acquired intraoperatively through 1-cm stepwise pullback along the aorta from the left subclavian origin to 20 cm. IVUS aortic diameters were measured at the maximum phase during the cardiac cycle. The average values of major and minor axes diameters from both modalities were calculated at each location for comparison. Linear regression analysis was performed to evaluate correlation, and Bland-Altman plots assessed agreement between different imaging modalities.

RESULTS

During the study period, 26 patients underwent TEVAR. Of these, 20 patients had adequate CTA and IVUS images, providing 355 paired measurements. There was a high correlation between CTA- and IVUS-determined aortic diameters (R = 0.62; P < .001). However, Bland-Altman analysis showed that, compared with CT, IVUS resulted in larger aortic diameters, with the mean difference of 3.09 mm. There was a significant variability between IVUS and CTA with the standard deviation of difference (SD diff) of 4.56 mm. When stratified by the aortic position, a high degree of agreement was observed at the base of the left subclavian (position 0), with a mean difference of -2.69 mm and an SD diff of 4 mm. The agreement was the lowest at the angulated aortic segments (2 cm to 7 cm distal to the subclavian origin) with a mean difference up to 7.96 mm and an SD diff up to 8.27 mm.

CONCLUSIONS

IVUS imaging and centerline CTA may provide significantly different aortic diameter measurements, particularly in angulated aortic segments. Caution must be taken when sizing a stent graft using CTA alone, particularly in an angulated proximal landing zone.

摘要

背景

在胸主动脉腔内修复术(TEVAR)期间,准确确定覆膜支架的尺寸对手术成功至关重要。利用术前计算机断层扫描血管造影(CTA)的三维重建进行中心线测量是目前确定覆膜支架尺寸的标准方法。然而,该技术基于理想化的拉直主动脉,未考虑心动周期中主动脉直径的变化或患者的总体容量状态。血管内超声(IVUS)可提供与支撑钢丝垂直的主动脉实时横截面成像,从而为TEVAR时确定主动脉直径提供一种辅助方法。

方法

对2015年7月至2015年12月期间因非创伤性主动脉病变接受TEVAR的所有患者进行回顾性研究。术前CTA图像在专用三维工作站上重建。从左锁骨下动脉起始处至其远端20 cm,以1 cm间隔在长轴和短轴上进行CTA中心线主动脉直径测量。术中通过沿主动脉从左锁骨下动脉起始处至20 cm进行1 cm逐步回撤获取IVUS图像。在心动周期的最大相位测量IVUS主动脉直径。计算每个位置两种方法测得的长轴和短轴直径的平均值进行比较。进行线性回归分析以评估相关性,并用Bland-Altman图评估不同成像方式之间的一致性。

结果

研究期间,26例患者接受了TEVAR。其中,20例患者有足够的CTA和IVUS图像,提供了355对测量值。CTA和IVUS测定的主动脉直径之间存在高度相关性(R = 0.62;P <.001)。然而,Bland-Altman分析显示,与CT相比,IVUS测得的主动脉直径更大,平均差值为3.09 mm。IVUS和CTA之间存在显著差异,差异标准差(SD diff)为4.56 mm。按主动脉位置分层时,在左锁骨下动脉起始处(位置0)观察到高度一致性,平均差值为 -2.69 mm,SD diff为4 mm。在主动脉成角段(锁骨下动脉起始处远端2 cm至7 cm)一致性最低,平均差值高达7.96 mm,SD diff高达8.27 mm。

结论

IVUS成像和CTA中心线测量可能提供显著不同的主动脉直径测量值,尤其是在主动脉成角段。单独使用CTA确定覆膜支架尺寸时必须谨慎,尤其是在成角的近端锚定区。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验