Department of Chemical and Biological Engineering, University of Colorado , Boulder, Colorado 80303, United States.
Institute for Molecular Engineering, University of Chicago , Chicago, Illinois 60637, United States.
ACS Appl Mater Interfaces. 2017 Aug 23;9(33):27927-27935. doi: 10.1021/acsami.7b07179. Epub 2017 Aug 15.
Photonic crystal hydrogels composed of analyte-responsive hydrogels and crystalline colloidal arrays have immense potential as reagentless chemical and biological sensors. In this work, we investigated a general mechanism to rationally tune the sensitivity of photonic crystal hydrogels consisting of stimuli-responsive polymers to small molecule analytes. This mechanism was based on modulating the demixing temperature of such hydrogels relative to the characterization temperature to in effect maximize the extent of phase separation behavior; thus, the volume changes in response to the target analytes. Using ethanol as a model analyte, we demonstrated that this mechanism led to a dramatic increase in the sensitivity of optically diffracting poly(N-isopropylacrylamide) (pNIPAM) hydrogel films that exhibit a lower critical solution temperature (LCST) behavior. The demixing temperature of the pNIPAM films was modulated by copolymerization of the films with relatively hydrophobic and hydrophilic comonomers, as well as by varying the ionic strength of the characterization solution. Our results showed that copolymerization of the films with 2.5 mol % of N-tert-butylacrylamide, which is hydrophobic relative to pNIPAM, enabled the detection limit of the pNIPAM films to ethanol to be lowered ∼2-fold at 30 °C. Additionally, increasing the ionic strength of the characterization solution above 200 mM resulted in a dramatic increase in the extent of contraction of the films in the presence of ethanol. Ultimately, it was demonstrated that as little as 16 g/L or 2 vol % of ethanol in water could reliably be detected, and that the sensitivity of the films to ethanol was predictably greatest when operating near the phase transition, such that even small additions of the analyte induced the start of demixing and the collapse of the hydrogel. Such a mechanism may be extended to photonic crystal hydrogel sensors prepared from other stimuli-responsive polymers and more broadly exploited to enhance the utility of these sensors for a broad range of analytes.
由对分析物有响应的水凝胶和晶体胶体阵列组成的光子晶体水凝胶在无试剂化学和生物传感器方面具有巨大的潜力。在这项工作中,我们研究了一种合理调节由刺激响应聚合物组成的光子晶体水凝胶对小分子分析物的敏感性的一般机制。该机制基于调节此类水凝胶的分相温度相对于特征温度,以有效地最大化相分离行为的程度;因此,响应目标分析物的体积变化。使用乙醇作为模型分析物,我们证明,这种机制导致具有较低临界溶解温度(LCST)行为的光衍射聚(N-异丙基丙烯酰胺)(pNIPAM)水凝胶膜的灵敏度显著提高。通过将相对疏水和亲水共聚单体共聚以及改变特征溶液的离子强度来调节 pNIPAM 膜的分相温度。我们的结果表明,将 pNIPAM 膜与相对疏水的 N-叔丁基丙烯酰胺共聚 2.5 mol%,可以将 pNIPAM 膜对乙醇的检测限降低约 2 倍,在 30°C 下。此外,将特征溶液的离子强度增加到 200 mM 以上会导致乙醇存在时膜收缩程度急剧增加。最终,证明可以可靠地检测到水中低至 16 g/L 或 2 体积%的乙醇,并且当操作接近相转变时,膜对乙醇的灵敏度最大,即使是分析物的少量添加也会引发分相和水凝胶的崩塌。这种机制可以扩展到由其他刺激响应聚合物制备的光子晶体水凝胶传感器,并更广泛地利用这种机制来提高这些传感器对广泛分析物的实用性。