Patrick Amanda L, Cismesia Adam P, Tesler Larry F, Polfer Nicolas C
Department of Chemistry, University of Florida, P.O. Box 117200, Gainesville, FL 32611-7200, U.S.A.
Int J Mass Spectrom. 2017 Jul;418:148-155. doi: 10.1016/j.ijms.2016.09.022. Epub 2016 Oct 7.
The effects of electrospray ionization (ESI) solvent and source temperature on the relative abundance of the preferred solution-phase (N-protonated; i.e. amine) versus preferred gas-phase (O-protonated; i.e., acid) isomers of p-aminobenzoic acid (PABA) were investigated. When PABA was electrosprayed from protic solvents (i.e., methanol/water), the infrared multiple photon dissociation (IRMPD) spectrum recorded was consistent with that for O-protonation, according to both calculations and previous studies. When aprotic solvent (i.e., acetonitrile) was used, a different spectrum was recorded and was assigned to the N-protonated isomer. As the amine is the preferred protonation site in solution, this suggests that an isomerization takes place under certain conditions. Photodissociation at the diagnostic band for the O-protonated isomer (NH stretching mode) was used to quantify the relative contributions of each isomer to ion signal as a function of ESI conditions. For mixtures of methanol and acetonitrile, the relative contribution of the O-protonated gas-phase structure increased as a function of methanol content. Yet, substituting methanol for water resulted in a marked decrease of isomerization to the O-protonated structure. The source temperature (i.e., temperature of a heated desolvation capillary) was found to play a key role in determining the extent of isomerization, with higher temperatures yielding increased presence of gas-phase structures. These results are consistent with a protic bridge mechanism, in which the ESI droplet temperatures, dependent on endothermic desolvation and radiative heating from the capillary, may determine the isomerization yield.
研究了电喷雾电离(ESI)溶剂和源温度对对氨基苯甲酸(PABA)在溶液相中(N-质子化,即胺)与气相中(O-质子化,即酸)优势异构体相对丰度的影响。当PABA从质子溶剂(即甲醇/水)中进行电喷雾时,根据计算和先前的研究,记录的红外多光子解离(IRMPD)光谱与O-质子化的光谱一致。当使用非质子溶剂(即乙腈)时,记录到不同的光谱,并将其归属于N-质子化异构体。由于胺是溶液中优先的质子化位点,这表明在某些条件下会发生异构化。利用O-质子化异构体的诊断带(NH伸缩模式)处的光解离来量化每种异构体对离子信号的相对贡献,作为ESI条件的函数。对于甲醇和乙腈的混合物,O-质子化气相结构的相对贡献随着甲醇含量的增加而增加。然而,用甲醇代替水会导致异构化为O-质子化结构的显著减少。发现源温度(即加热去溶剂化毛细管的温度)在决定异构化程度方面起着关键作用,温度越高,气相结构的存在增加。这些结果与质子桥机制一致,其中ESI液滴温度取决于毛细管的吸热去溶剂化和辐射加热,可能决定异构化产率。